Search: Gradiente
Results: 1318
Make Model Symptom Problem Solution By
GRADIENTE HRM-290S
Vertical closed intermittent or closes after some time of use D705 e d707 Replace both for 1n4148 even if it is measuring as good Bruno Capozzoli
GRADIENTE TV-2924 CIN
SAM
Beeping at the power supply as if it were a shorted flyback C509 330mf 400v exhausted Replace c509 carlosss
GRADIENTE TV-2924 CIN
CIN SAM
Whistling at the power supply as if it were flyback C509 330mf 400v exhausted Replace the same carlosss
GRADIENTE TV2920
Vertical closed Poor contact on the vertical CI pins Resolve everything ready! orlando lott
GRADIENTE TF2952
Bowl effect on the screen, or pincuchion defect Ew q403 circuit with pci failure BRUSKE
GRADIENTE TV 2922
I'm sound If you have already reviewed everything ex. memo, you from the sound ci etc.. see c-602 smd next to the cracked sound ci. Master Eletronica
GRADIENTE GT - 2011
Image completely embedded, without definitions. Solution: change kinescope socket (tube) BARRETO CRUZ
GRADIENTE 1421
PCI650
League 2 seconds log off Micronas with cold solder and it doesn't turn on even after resoldering Replace the r 55 180k and c 405 22k and release the fley back pin and turn it on, it appears vertically closed, connect the pin again and everything works fine luiztvsom
GRADIENTE TV-2020
Without secondary power supplys C808 8k2 shorted Replace for another one with high insulation jasvan souza
GRADIENTE TF2953
Closed horizontal C429 364j 630v Replace EletroClaudio Aguas Belas
GRADIENTE D-860
It doesn't turn on the power supply ci when replacing it, it shorts out It's the power supply capacitor 22ufx400v which is very defective and runs out @@@ Ci top253, cap 22ufx400v EETRONICA ARNI-L. LEAL- SC
GRADIENTE D-860
It doesn't turn on the power supply ci when replacing it, it shorts out. It's the 22ufx400v power supply capacitor, which is very defective and runs out. Ci top253, cap 22ufx400v EETRONICA ARNI-L. LEAL- SC
GRADIENTE GBT2911
No stand by, normal voltages. does not turn on Change the 20,250 crystal 20.250 Eletrônica Nel
GRADIENTE M-34I
Turning off by itself After brainstorming a lot with this TV, the Q542 was the cause of this defect All I had to do was remove the q542 from the board and the problem was solved and it was only possible with the advice of another technician who posted this tip PATRICK
GRADIENTE GT2022
Defect does not turn on without +b and protecting Cause: capacitor 823 of 471 x2kv shorted klein
GRADIENTE HT-M 299S
Vertical with a line in the middle of the screen, but with a shrunken image at the bottom and top Check 26v voltage, if it is low, change rf-542, it has changed! .... joelton / infoaçu eletronica
GRADIENTE HT-M299S
Vertical top of shrunken screen Check 9v ci 541 power supply If it is low, replace the replaced fr-543 resistor..... joelton
GRADIENTE TF 2140
When I turned on the TV it just kept blinking and didn't work. I replaced the c918 and solved the problem with the TF2140 gradient TV, thanks for the tips This email address is being protected from spambots. You need JavaScript enabled to view it.
GRADIENTE TV2021
SAMS
When turned on, it looks like a white screen with scan lines and then turns off. Replace 180k r-55 on the 180v line. João SF.
GRADIENTE HRM290S
TV with audio but no sync Defect ic,701 {tda 8361} and just change the TV ok sliva