☰

Gradiente Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: Gradiente
Results: 1318
Make Model Symptom Problem Solution By
GRADIENTE TF-2151
High power supply D806 changed, it's new! PCI 687
GRADIENTE TV 2020
Does not work, emitting an intermittent beeping sound D 803 and c 808 of 8.2 nf for 500 v short in the primary of transformer t 802 Vanoil
GRADIENTE TV2020
Super heating horizontal outlet Even with the original bu808dfi and complete overhaul it heats up too much Replace with 2sc5149 and only paial.eletros
GRADIENTE GBT2911
Sound coming and going depending on turning on and off and sometimes no sound during programming. normal video. Replaced capacitor 805-10ufx160v. It was open, causing replaces in the voltages of some circuits, I replaced it with 33μFx160v, because I didn't have the 47μF one, as they said to replace it. I also replaced c309, as the cover was completely shrunk due to the heat and had low capacitance, I inserted an x6 Luiz Fernando
GRADIENTE TF2140
Burning the power supply + vertical resistor 47k ceramic capacitor shorted near the stv9302 ci Replace
GRADIENTE TV1421
CDG 		Vertical closed from top to bottom Corrupted memory Replace to memory carlosss
GRADIENTE TV-1420
With a black stripe at the top replaces wide capacitor Wide capacitor joãotc
GRADIENTE TV-1420
Normal voltage of 150 volts gave power and then turned off, flashing the LED quickly and heating up the horizontal output, I replaced the flayback and it worked normally Flyback joãotc
GRADIENTE TF-2150
PCI687 		Turns on then turns off (led on). R55 150k, is next to c402 Replace hehe! Alextecnico
GRADIENTE TV 1423
Out of horizontal phase (black band on left side) Dz 701 zener diode with small leakage nadinho
GRADIENTE TF2151
Does not turn on or takes a long time to turn on (low 10.2v supply) C506 and c509 10/50v changed Replace the two Phatal
GRADIENTE TV2021
Horizontal black lines Roasted r304 Replace r 304 (1r5) no vertical George Pontes
GRADIENTE TV2020
Totally dead secondary power supply Zd 801 with leak (short) Replace zd 801 15v in the primary supply good luck. George Pontes
GRADIENTE TF2150
High power supply Cause: 841 resistor auterated klein
GRADIENTE PCI 122C / MS-550
When turning on the gradient device, the sound was very low and the FM was not tuned Cold solder sounds mainly on pin 5. The welds were redone and it works perfectly. IVES
GRADIENTE TS2960
Wide image with cushion effect D302, zener de 33v com fuga Measure the voltage in this zener which is around 20v. If it's a little below that, replace the zener immediately. eletronicarotary
GRADIENTE 2044
BU-OA-3 		Does not turn on - turns on standby and turns off Burst electrolytics trace ic102 and q103 without measuring Replace without measuring luiztvsom
GRADIENTE GT1410
Doesn't start. Retirar capacitor 10 uf x 50v colocar capacitor de 47uf x 50v. Ozias
GRADIENTE GT1410
Doesn't start Retirar capacitor 10 uf x 50v colocar capacitor de 47uf x 50v. eletronica maron
GRADIENTE HT-M277S
Protection acting after a few seconds R-563 3k9 changed giving 5k on x-ray Replace LUCIANO