Grundig Repair Tips
Search: Grundig
Results: 948
Results: 948
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| GRUNDIG |
T55-2401 TEXT
E1 |
No voltage from g2 | Replaces the transfer lines per hour 80062 and already has g2 voltage but with defective colors | Americo pereira | |
| GRUNDIG |
GDP-1400
|
Doesn't turn on anything, no voltage on the secondary | C111, 2200mf/10v. u901, ice2a0565 | Replace capacitor on secondary and ci on primary | S.O.S. Electrónica - Fundão |
| GRUNDIG |
CUC5303
|
Swapping tda8214 for tda8215 (no sound) | Change r522 from 47k to 39k and remove r529 | António Correia | |
| GRUNDIG |
T51-060
CUC6300 |
Horizontal very open, r572 open | Replace r572, c573 and c574 | Replace r572, c573 and c574 | gloop |
| GRUNDIG |
ST55-908/8 DOLBY
CUC2121 |
Turns on does not start (stby) | Ic vertical (tda8174) | Ver c53054 (1μF/100v), br81053 (2,2r) | JOAQUIM CUNHA |
| GRUNDIG |
MW70-2699NIC/T0P
CUC2059 |
Does not turn on; led off | Fusivel si62501 (2ap/250v) ; ptc (t209) | joaquim cunha | |
| GRUNDIG |
P37-060
CUC6300 |
Vertical closed | Open r591 and tda8174w with pin 1 in dc | Subst r591 por 0 .68r tda8174w | camane |
| GRUNDIG |
T-55 830 TEXT
CUC 7303 |
White line in the middle of the screen | Vertical deflection failure | Tda 7303 replacement | Ruca23 |
| GRUNDIG |
8214
|
Color bars on the screen approximately 5cm wide | Cond. electrolytics 4.7uf/63v without capacity (one in each video output) | SIMP | |
| GRUNDIG |
CUC 2103
CUC 2103 |
It tries to start and then goes to standby, increasing the screen and tsound is a horizontal stripe when it tries to start! | Ic 50010 (vertical IC tda1771) shorted, r54006 open | Replace ic50010, r54006, c52002, c63054 (electrolytic next to ic do vertical) | CarlosVale |
| GRUNDIG |
CUC6300
CUC6300 |
Intermittent image loss, loss of image and loss of sensitivity (white screen) | T936/bc548 flashing | Replace t396/bc548 | SIMP |
| GRUNDIG |
M55-5501
K2 |
Image two seconds later goes into standby sometimes lasts two or three hours | C651 low capacity d611 leaking | obombeiro | |
| GRUNDIG |
XENTIA 42LXW
|
Does not tune through bdo tuner | Replace tuner or 4mhz crystal inside it | jose almeida tavares | |
| GRUNDIG |
ST-72-760/8TOP
CUC5365 |
Alloy does not start, r576 with high temperature | Transformer mat29201.029.10 (hr6514) | JOAQIM CUNHA | |
| GRUNDIG |
T55-549
CUC5302 |
Does not go out of standby, it immediately goes into protection | (t583)bc548 with leak | TELEGAIA | |
| GRUNDIG |
CUC3400
|
Return lines and excess shine | Verificar zener d707 (4,7v), c711, c731 | ||
| GRUNDIG |
CUC3400
|
Inop. 800ma fuse blows | Check c667(2u2), c653(4n7), d663, d664 | ||
| GRUNDIG |
T55-743 EURO
CUC6300 |
Interference in the image | Check internal welds of tuner | ||
| GRUNDIG |
G1000
G1000 |
Tsound is no image dark screen with sidebar | Tr300 (bc847) leaking | ||
| GRUNDIG |
CUC7303
|
Flashing LED does not start | C667 |