Lg Repair Tips
Search: lg
Results: 4960
Results: 4960
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
29FS4RL
|
Power supply goes to 180v and drops. | C808 and c809 (stowed/disabled) | Replace | PIMENTA |
LG |
32GL60UR
|
Screen keeps flashing | Check resistors r609 to 612, glue underneath them can cause this defect, changing the value of the resistor. | pardalzito | |
LG |
21FU4RLG
|
Normal image without sound in rf, av has sound | Enter opm4 service mode and change fm-pre to 52, it was at 0. | Henderson(hndrsn) | |
LG |
RP-21FB32BRS
|
With sound and without image and with OSD. | Leaky and crusted diode d502 | D502 leaking and crusted. | diego lima de nova timboteua pa |
LG |
32FS4RNP-LE
MC-05HA |
TV starts and then turns off. | H-out output short circuited (2sc5858), resistors r877 and r878 open. | Replace the h-out transistor and resistors r877 and 878 (1.7Ω 2w). | leitemarcellus |
LG |
21FU6TL
|
Does not turn on / does not come out of stand-by | Cap.515 of 470-10v - horizontal oscillator | Replace the same | eletronicaapolo |
LG |
40LV3500
L*01U |
Inoperative, power supply damaged. | Diodes d501~d504 (1n4007) short circuited + fuse f101 open. | Replace all 1n4007 diodes and the 3.15a 250v fuse | leitemarcellus |
LG |
L203WT-BX
|
Monitor turns on and turns off after a few seconds, you can see that one of the lamp transformers heats up slightly. | Junction of the transformer wires with the lamp terminals charred by heat or poor contact. | Dismantle the entire screen, clean the lamp terminals well and reconnect. if possible, isolate with natural curing silicone (not acetic). | ASSOLINI |
LG |
21FJ6RB
|
Lg tv black bands on the sides without rf signal with retrace lines av works with blue band in the center | Memory | Replace the same | Adrianosecreta |
LG |
29FS4RL
|
It doesn't work without + b just knocks the relay | Photo coupler | DANIEL SOLÂNEA PB | |
LG |
21FB32BRS
RP 21FB32 |
LED on, press key, start, oscillate and cut off | Flay bek | Just replace and run for joy | eletronica martins ubatuba |
LG |
42LG60FR
|
Catching fire in the power supply capacitor c 700 220k x 450v | C 700 220k x 450v | 220k x 450 v | ELETRONICA MAURI JUNIOR |
LG |
32LD420
|
Screen flashes 3 to 4 times and turns off | Diodo zener com fuga d512 15v | Alvaro (prolar) | |
LG |
CP-20B85
|
It doesn't oscillate, it just turns on the LED. | C406 100uf 16v dia de ze dias | Replace | EletroClaudio Aguas Belas |
LG |
CP20B85
|
Lack of contrast. | D=502 open | Replace for a 1n 4148 and blz | ELETRONICA MEDEIROS |
LG |
21FU1RLG
|
Does not tune the channels. | 30 volts of tuning voltage were missing. the resistor 114 (30k) was open, I replaced it and everything was ok. | valmirgold | |
LG |
RP-20CC25
|
STBY LED goes out, normal sound on all channels and normal secondary voltages, but the horizontal one does not start. | Cold solder between the metal ring used to reinforce the solder on terminal 1 of the flyback and horizontal output collector. | A little tip: this cold solder was invisible even with the magnifying glass. I solved it as I usually do with this type of crack: preferably at night, turn off all the lights in the workshop and lightly twist the plate, a small spark should appear, mark the spark point and turn on the lights and redo the welding, it's a shot and fall. I delete them all | Altevir Lima/ Valparaíso Eletrônica/ PA |
LG |
21FJ6RB
|
This TV gave me a lot of trouble, it arrived with a burnt horizontal outlet, I replaced the horizontal outlet and the TV didn't work, it turned on and then came apart, I replaced everything that was part and it didn't solve it, after a lot of patience I discovered the defect was a 1k pressure resistance r842 near the transformer. | 1k precision resistor position r842 | Diego lima nova timboteua | |
LG |
21 FU1RL
L3 |
It takes a long time to turn on and when it does turn on it has a black stripe at the bottom. | C307 and c311 with low capacitance. | Replace c307 and c311. | Rondinele |
LG |
20CC25
|
White screen with retrace | Ic-501 with the rgb outputs with voltage above normal, then just change d-502 which was leaking for the contrast to act normally. hug | jorge fontes |