Search: lg
Results: 4875
Make Model Symptom Problem Solution By
LG CP-20J50
MC-83A
Closed vertical, varying height or tremulous Replace c316 and c308 ECJ
LG RP20CB25A
MC059A
Without horizontal synchronization. R512 of 4k7, was measuring 5k1 (it comes out of pin 18 of ic501. Just replace the precision resistor. gmcmaster10
LG 29CC2RL
Tv with red screen and retrace lines Tube socket Replace the same eletronica shalon
LG 29FS4R
Turns off after a few seconds. Protection problem. Testing r843, 220k. lou
LG RP-20CB67
Sometimes I tuned in and after a while I left Several tests were carried out on the 33v +b and clok and data and the signal was inserted into the fi, it was found that it was the tuner The replace of the same HIPERELETRONICA SERVICE(MARCELO)
LG RP-14CB25A
Without horizontal synchronism, both in rf and av Several tests and rewriting of the eeprom were carried out, the famous diodes were replaced and nothing was done until we reached the conclusion of the micro Micro ic 501 replacement HIPERELETRONICA SERVICE(MARCELO)
LG W
Turns off after 3 seconds Wire that turns on the LCD lamp loose Disassemble the LCD and solder the wire
LG 21FU4RL-LS
Alters for 5k6 Shameless breastfeeding Alters for 5k6 EletroClaudio Aguas Belas
LG RP-20CC25
Turning off after a few minutes, normal image and sound. Fr403 (1,2r) ok. In this case it was the r420 (240k) connected from ground to the emitter of the q403 close to the fly-back. It was open. Manoel (Noca)
LG 21FJ6RB
Shorted flyback Doesn't work I replaced the original flyback with the Toshiba at- 2079=ao it was a gem. oilec
LG 29CC2RL
Doesn't start Transistor 809 open emitter Obs don't turn on the relay This email address is being protected from spambots. You need JavaScript enabled to view it.
LG 21SA1RL
L4
No sound or sound only in the av Ic 605 la 72703 www.teteletronica.com.br
LG 20CD2R
MC59
Does not turn on (LED on, normal power supply) seen protection, FBT, clock, eepron everything ok R 512=4k7 open on pin 18 of the micro francineutom lima
LG RP-29CC26
Knocking relay and blinking led - doesn't work. Zener diode 803 6.2 volts short On the schematic it says 5.1 volts, on the chassis it says 6.2 volts. std eletronica(PALMEIRA)
LG 21FS4RLG
Blurred image. turning off after a while and with a light point in the center of the tube. After cleaning the socket and re-soldering it, the focus was normal and the light spot came out. After replacing the damaged r420, the TV no longer turned off. Gilcimar Rocha Pereira
LG RP-14CB25A
Reduced width with return lines and then turns off Photo coupler You can put the photo 817 and it works normally ELETRONICA ELETROSONIC
LG 29FS4LG
Vertical half closed when you twist the PCI normalizes Change the vertical output (with internal flashing) see smoked resistor under the ci WARLEY CESAR
LG HT502
No sound, turns on normally and outputs ok. Reprogram eeprom, see service manual joaomvjr
LG 32LG30R
The LED lights up, but there is no image or sound. stays on standby Replace the r 128 with a 15k one, if it doesn't work increase it to 22k, remove c108- zd111 and z112 and replace c 207 and 208, both 3300/10v. joaomvjr
LG 37LH20R
Turns on, normal, disappears image and remains with sound Protection acting Add res 220Ω between the 12v line and pwm-dim and zener 3.3v with cathode to pwm-dim and the anode to ground cabessãonatal