Lg Repair Tips
Search: lg
Results: 4960
Results: 4960
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
21FU6TL
21FU6TL |
Vertical closed in the center with two wavy lines at the bottom and top of the screen. The line at the top did not complete the screen. | Deflector | Binho eletro | |
LG |
21FS2RLG
|
Vertical time closes time opens from the middle upwards with lines of retractions as if using cold solder or a capacitor | Defective tda4863aj vertical output | Replace | EletroClaudio Aguas Belas |
LG |
21FU4RL
|
Doesn't turn on, tries to turn on but doesn't turn on | 27k r842, may be altered | Replace!!! | |
LG |
32LG30R
|
Sometimes it doesn't turn on, the LED turns blue as if it was going to turn on and turns red again. | Power supply board | Changing the complete board, maintenance on these boards rarely works. | |
LG |
CP20K40
|
Hissing, no channel tuning. When tuning it gave a lot of interference. | Primary power supply main capacitor | Elet house of monitors itumbiara-go | |
LG |
CP-14B85
|
Mirror image with a horizontal stripe on the left side | Ic 501 | Replace the same | Dan levita/ aracaju- se |
LG |
21FS4RLG
|
Turns off after a few seconds | Protection arming | Replace resistor r420. 220k | LOU |
LG |
29FE80
|
Heating until it burns | C411 | Guys, here's a tip: 2sd2689 has a diode, a tar of 2sd2689ls doesn't have one because most of them are fake. | luizandradina |
LG |
29FE80
|
Heating up until it burns out horizontal output, 2sd2689 | C411 open | Just replace the said, people be careful, there are a lot of these counterfeit exits, just burn them again | luizandradina |
LG |
21FU4RL-L3
|
Turns on and goes into protection immediately afterwards (arms and disarms) | Open vertical circuit diode d302 (1n4005) | After replacing it, the device started working normally again. | DIGITÉC ELETROICA |
LG |
14CB25A
14CB25A |
The TV doesn't turn on, the fuse blows when turning it on. | I replaced the str w6753 power supply regulator. I cold tested the photocoupler, it passes the test. But it doesn't solve the problem, the fuse blows. | I replaced the photocoupler. It was the misery of the photocoupler, make the replace without testing it and running for the hug. | Júnior/Maceió-Al |
LG |
CP-20B86
|
It has sound, it has plot, but the image is completely distorted (ghost) | L102 coil messed with broken ferrite | Replace-la and recalibrate-la | Paulo Sertel - Itararé SP |
LG |
RP20CD2R
|
Poor tuning and in low channels the image is dark and in high channels the image is very drizzled | Altered resistor r526 of 47k and r525 of 62k | Replacing the 47k resistor r526 and 62k r525 with 47k replaced the problem was resolved | |
DVD LG |
LG
|
The drawer opened but did not close | The belt was worn without pressure, so it didn't work properly | I replaced the belt and it was fine, opening and closing. | LULA SOM E IMAGEM |
LG |
RP14CB25A
|
Vertical closed | R. 313 | I just replaced and thanked God for the bread | dan levita |
LG |
RP21FE85G
MC-059A |
Problems with vertical, thin horizontal band in the center of the monitor and it turned off in seconds | Cracks in the ic 804, resolder it and the ic803 | Marcos | |
LG |
W1952TQ
|
No image white screen | Power supply capacitors and cleaning lvds flat cable | eletrotech ctba | |
LG |
21FU6TL
CW81B |
LED on but not turning on | Ci 9volt regulator | jesujm | |
LG |
CL21Z43MQ
|
200v high power supply does not turn on or light up the LED | Open fd803s | ELETROCLAUDIO AGUAS BELAS | |
LG |
29FX6CL
|
Turns on and then starts to go off and on until it goes out for good | Reg 3.3v shorted, supply high | Substituir o reg ld 1117v33 , ic 823 | EXPEDITO |