Lg Repair Tips
Search: lg
Results: 4956
Results: 4956
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
CM9730
|
No power supply sound missing voltages +35 and -35 pfc out with 178v | Changing the 3 1m resistors, tsound is no point in measuring, you have to change r917, r918 and r919, I changed them and the power supply worked | Alemao | |
LG |
42LS4600
|
When turning on the LED flashes but nothing works | When analyzing the power supply voltages, it did not have 12 and 24 volts, a low pfc power supply with 325 volts wsound it should have been around 380 volts | Replace capacitor c603 on the side of diode d602, it had a loss of capacitance | PROTEC ELETRÔNICA |
LG |
CM4350
|
No sound. 5v normal but 12v and 28v appears, but then drops | R709 (3r3) that feeds the open output switching. | Tecnoprom | |
LG |
29FX5CL
|
Turns on with the image closing on the sides and turns off obs power supply +b varying 110v to 90 | Tl431 | EletronicaArni L.Leal-sc | |
LG |
32LG80FR
|
Standby LED flashes blue 16 times, turns on without image | Capacitor c-270, open on the t-com board | After changing the TV, the image returned. | EDS-LELETRONICA |
LG |
39LN5400
|
Control functions ok, bus lights up but no image. | Releasing a flat from the tcon, the TV showed half of the perfect image, I thought it was a shorted display, but I found cap c18 on the v-con shorted. Just changed it and it was perfect. | Kezio | |
LG |
42LB5800
|
Turns on appears shortly after turning off backlight, only the sound remains, if you increase backlight and turn off energy saving it works normally for a while. | Q803 2nf20l with leak | Replace | Hndrs |
LG |
55UH6150
|
Dark image (not a LED defect) | Faulty LED circuit in the power supply. Tsound are many complaints about this defect about this model on the internet. Don't just pay attention to the damaged component. | Replace the ci ic601 (map3516) and the fets q201 and q202 (5n40). preventively, I replaced the 2 electrolytic capacitors (10μF x 350v) and 2 polypropylene capacitors (470nf x 400v) | PIXEL ASSIST |
LG |
CM4350
|
Does not turn on, inoperative, no voltage 5.6v | Power supply mosfet transistor shorted. | Replace with an 08n80c3 or equivalent. After the replace, the sound worked again. | Tiago C. Neves |
LG |
28MT48S
|
Doesn't start | Shorted wifi card | I removed the connector and turned on the TV | Tec Center |
LG |
22MA33N-PS
|
The image keeps flashing on LG and it doesn't turn on. | External power supply with open filter capacitor. | eletrofepar | |
LG |
CM8350
|
One of the channels goes silent, without sound, and after a while, it goes into protection, sometimes. | Affected output driver failure | Leakage in the capacitor connected to the driver's CSD pin causes the voltage, which should be 5 volts, to drop, disabling the output switching. | Davi.sls |
LG |
CM8350
|
Display lights up normally, but tsound is no sound on any of the channels. | One of the optical barriers had a broken pin from so much oxidation. | All I had to do was replace the barrier and the sound returned to normal. | 2000 |
LG |
21FU4RL
CW81A |
Burning the c6090 horizontal output | Replace c414 18n and due to the large number of counterfeit components, replace the c6090 with a c4429 position q402., | Replaces the c6090 with a c4429. It has to be original! | MARCONES DE ARARIPINA-PE |
LG |
55LA6210
|
The LED flashes 1 time and does not turn on | D603 in pcf power supply | Divino Moura | |
LG |
32CS3400
|
Turns on and backlight does not come on | 24v power supply missing | Replace ic101, sc1g311 | laercio |
LG |
42LB9RTA
42LB9RTA |
No audio | R484 and r485 sda and scl line. 100r | Replace | Alex Semitron |
LG |
42LB9RTA
42LB9RTA |
No audio | R484 and r485 sda and scl line. | Alex Semitron | |
LG |
42LD420
|
It turns off stand-by but it doesn't turn on and it doesn't turn on the backlight either. | Main board killing the 3.3v. | Ceramic capacitor c471 shorted on the main board. (near the video flats) | Persio(TVCompany) |
LG |
50PN4500
|
With sound without image ysus short | Burns out because of capacitors c653, c654, c681, c682, c686, c687, c673, c674, change them and q401 and q402 (you can use the FGD4536), change q508 (use a 5n50), change q403 and 404 30f126 (you can 30f124). | Eletrônica Hunters |