☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 29PT4635
No image with characters Tsound micro So replace orlando
PHILIPS DVP3124
It doesn't turn on using the panel button, just the control, and it can turn itself off Check the voltage on the pci mother pin 3 connector for the front pci it should be around 2v4 if it is low it could be c75 smd with a leak near the connector. Bruske
PHILIPS 20PT3331
03.1L 		I'm sound Capacitor smd c2201 aberto Alvaro (prolar)
PHILIPS 29PT4631
Power supply does not start, power supply oscillator power supply with low voltage on pin 1 (from 13v to 6v) Photo coupler Ronie Grein
PHILIPS 20PT120A
L7 		Does not tune channels Without catching channels R3617 12k open dede som
PHILIPS 40PFL3605D
Won't turn on, fuse blows Q501, d510, r517, d210 Ronie Grein
PHILIPS FWM570
Heating and burning transistor 7211 pzt 2222a Diode 6108 12 volts with leakage Take it off the board to test because on the board it measures as good antonio nobrega(patos pb)
PHILIPS 21GX1668/78
Poor contrast R3460 changed Replace deuner
PHILIPS 20PT3336
Dead Floor 6765 Replace the same eletronicaapolo
PHILIPS 20PT228
Nothing works, the stand bay LED doesn't even light up Secondary supply +b low oscillating from 50v to 67v Replace do ic 7520 (tea 1507) LOU
PHILIPS 21PT9467
Image closes after a few minutes Deflector Adjustment or replace. LO
PHILIPS 20PT3331
Vertical closing at the top and turning off after a few seconds Drained 2460 capacitor Replace for a good one. Ademir solânea pb
PHILIPS 14PT3131
When cold... in a few more seconds it turns off, but when it heats up it works normally. It could be the vg2 that is out of adjustment, adjust the vg2. jayjunior
PHILIPS 21PT8467/78
Turns on then turns off triggers protection Rusty tube no g2 On g2 it oxidizes and shorts out g2 and with the g2 wire give some sparks to the pin obs. resolve, but the defect may return again (be careful when notifying the customer) arasonic
PHILIPS 20PT122A
Don't tune in Eprom Rewrite eprom data DIGITAL TEC ELETRONICA
PHILIPS 14PT3336/78
LO6 11 		Blue screen with traces and then turns off Kinescope socket with humidity, due to relative humidity on rainy days and oxidation on its internal terminals Replace the kinescope socket with new and good quality PAULO SERTEL ITARARÉ SP
PHILIPS 14PT3336/78
L06.1L 		Blue screen with traces and then turns off Socket with humidity, due to relative humidity on rainy days and oxidation on its internal terminals Replace the socket with a new one of good quality PAULO SERTEL ITARARÉ SP
TV PHILIPS 29PT458A/78
* 		When the TV heats up +/- 1 hour of time it turns off, after this time it starts to turn off continuously and then it doesn't obey but nothing starts working again only if it is turned off with the main switch and everything comes back on again. Encontrei q7450(smd) proximo do flay back I put bc 547 and it was normal wagner
PHILIPS 20PT120A-PT110-PT210-PT121-PT220
This TV turns on the power, the standby LED blinks about 5 times and does not turn on the power supply +b 95v ok @@@ Resolder or no smd c2442 Help yourself leave your tip ELETRONICA ARNI-LEOBERTO LEAL/ SC
PHILIPS AS 800
Turns on the display and goes off and only the stop is on Open transistor t 7252 and open resistors 3333e 3334 and 3300 and 9601 carlos jpramos