Samsung Repair Tips
Search: samsung
Results: 3802
Results: 3802
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG |
UN32FH4205G
|
Audio only. | LED bars with many shorted LEDs and one open. | I replaced the LED bars. I lowered the inverter current to avoid return. I added another resistor 0r47 in series to r9830. measurements went from 453ma (in maximum backlight) to 371ma. | Eletrônica R-Tec |
SAMSUNG |
HT-Z320T/XAZ
|
Turning off after five minutes + or - | Short in circuit | Smd capacitor fc3 (10μF) shorted, fq4 open (a1273) replaced, they are near the top of the fan. | RNSPTEC |
SAMSUNG |
UN55MU6300G
|
Power led flashing | D9002c | Diode d9002c (mur460g) shorted | ANTONELLO |
SAMSUNG |
UN32FH4205G
|
Does not change to AV input, it is only component input | Defect in AV and component input connectors | I just had to replace the input connectors | JG REFR |
SAMSUNG |
LN32B530P2M
|
Reddish image, even after factory reset with the service remote | Adjust the following adjustments on the nail, note that the tip I took from a website and tsoundfore is not mine, but follow the link | Hello friends... I managed to solve the problem in the following way: menu adc result 2nd_r_offset was at 148, I lowered it to 113, as the other 2nd_g_offset and 2nd_b_offset were also at 113, so the reddish image disappeared, even without touching the wb menu - r_offset which was 128. It must be a firmware bug, even though it's original, because I didn't update it and as soon as I connected the netbook, this happened after turning the TV off and on the other day. tip seen on the website: https://www.htforum.com/forum/threads/samsung-ln26b450-imagem-avermelhada-apos-conectar-vga.137683/ | MIGUELTV |
SAMSUNG |
LE32A330
|
Blurred image and colors | Era a t-con i.c. as15 | fersan | |
SAMSUNG |
HT-C550 HT-C553
|
Does not turn on, no +5v, completely inoperative | Smd transistor ksc1623-l in position qm3, can put 1am | Replace smd transistor ksc1623-l in position qm3 and run for hug! | HAHNRAHN |
SAMSUNG |
CL29A551GQ
|
Japan Fund A Nishida Horizon et al. | Cr402s cr403s | Replace the cr402s and cr403s and replace the bu2527dx with the bu2720dx or bu2520af and that's it, the TV will work normally. God be praised! | Sinailson furtado |
SAMSUNG |
MAX A66
|
Protected message when connecting. | Cleaning the CN2 and CN3 connectors. | amsinformatica | |
SAMSUNG |
LN32A550
|
Bad image, inverted colors, sometimes no image | Cabo lvds | Disassemble the terminals and clean, or replace them! | Rodrigo cofferi |
SAMSUNG |
UE40F6200AK BN44-00616A
|
Doesn't work, qp801s burnt out | Fp801s(5a), qp801cs(13nm60c), rp811(0,47ω), rp810(100ω), rp813(20ω), dp801(bav70t), icp801(sem3050), dp808c(sf38g), cp812(22µf/50v) | Andrew | |
SAMSUNG |
CL21K40MQ
KS9C |
Turn on is to turn off quickly with a very loud chirp on the flyback | Shortened deflector all black inside | I put another good one it was good again | Algustinho eletrônico |
SAMSUNG |
CL-21Z43MQ
|
Turns on with sound and no image, low power supply. | Tl431 regulator | Pardal - X | |
SAMSUNG |
LN40J5200
|
Just backlight on with sound no image | On the main PCI close to the power supply connector f202, on the v-con fp1= 3a, shorted cp30 next to cp31 close to the up1 ci | Measure the v-con fuse, if it is bad, replace the components mentioned | NEI |
SAMSUNG |
T22B300LB
|
Doesn't start. 3v3 is missing, which comes from +5v, it has a weak 1.2v. | Ic 202 it is a 3v3 regulator, 1g1 = subs 78l33 philips, the 1g1u pin1 ground, 2pino2 input 5v+, p3 output3v3 | Place the 78l33 philips pin 1 output 3v3, pin2 ground, pin3 input 5v+ | guinga sdia goias |
SAMSUNG |
UN48J5200AG
|
Varying colors on the screen blue, green, red. | In my case, I just changed the t con. | Luciano | |
SAMSUNG |
UN48H4200
|
Turns on, tsound is sound, turns on the LEDs and tsound is no image. It doesn't have the 12 v that powers the screen. | On the main board, q201=(1e) open. It is next to resistors r808, r242 and r241. good luck!!! | JOÃO CARLOS ELETRÔNICA | |
SAMSUNG |
PSPF411701A BN44-00161A
|
Doesn't work, lacks +5v stdby ccts | Check swap: f801s, fb801, icb802, db810, db811, db812, zdb804, db806, db807, cb813 | Andrew | |
SAMSUNG |
PS42Q97HDXXEU PS42C91HXXEC BN44-00204A DYP-42W3
|
Does not work, fault in qs801 and qs802 | Check swap: f801s, fm801s, qs801, qs802, ds804, ds803, rs814, rs812, ics801 | Andrew | |
SAMSUNG |
PS42Q97HDXXEU BN44-00159A DYP-42W2
|
Does not work, fault in qx801 and qx802 | Check swap: f801s, fx801s, qx801, qx802, dx803, dx804, rx813, rx815, icx801 | Andrew |