Sharp Repair Tips
Search: sharp
Results: 1789
Results: 1789
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SHARP |
DV5103
|
Lin fault , or low def pic or loss mem , tuning , so | Ic1411 nvm sharp ch-ix1409cjho | ||
| SHARP |
DV5103
|
Dist sound playing back vhs hifi using a/v ip.chan | 10k resistors are fitted , from neg side c1374 to deck , from neg side c1372 to deck , from neg side c1394 to deck , from pos | ||
| SHARP |
DV5101H
|
Wont come out of sby | R612 open - change r612 with 2.2Ω and fit r612 2.2Ω sharp -xz0204bmzz , j-13 1.2Ω sharp vrd-ra2hd1r2j | ||
| SHARP |
DV5101H
|
St/by only | Ht high at 170v (113v), opto cnx82a faulty but still no go - link 147 in 25v line was o/c (an inductor) fitted wire link in lieu & now ok | ||
| SHARP |
DV5101H
|
Dead with smell of burning | R705 overheating - d708 s/c | ||
| SHARP |
DV5101H
|
Dead maybe smell of burning d708 s/c r705 o/c | Sharp issue repair kit | ||
| SHARP |
DV5101 DV5103
|
Stuck in stby: no vertical drive: colour faults: d | All can be caused by ic1400 vsp replace ptn rhix426bmzz | ||
| SHARP |
DV5101 DV5103
|
Stuck in stby : pic distortion : white pic : no os | All can be caused by ic1404 tvpo replace ptn rhix1443bmn5 | ||
| SHARP |
DV5101
|
No st/by | Chopper tfmr hi res on 5v winding | ||
| SHARP |
DV3770H
|
To access service mode | Link pins 3 & 6 of conn tb & press "mode" on r/c. "service" appears; select with "mode+ & -", adj with "chan+ & -" | ||
| SHARP |
DV3761H 4BSA
|
Field int | C512 82nf field ramp/charging cap to pin 6 ic801 int | ||
| SHARP |
DV3760H 4BSA
|
No start up | C604 1000mfd 16v o/c | ||
| SHARP |
DV3760H 4BSA
|
Dead but all psu secs ok apart from 13v | D602 faulty tho' measured ok | ||
| SHARP |
DV3760H
|
Vertical stripes on left side esp dark scenes | Fit 1k8 in place of jumper wire r895 sharp vrd-ra2hd182j | ||
| SHARP |
DV3760H
|
Dead with s/c across line o/p transistor | Check d601 1n4937 | ||
| SHARP |
DV3760H
|
Dead - no o/p from psu | D601 1n4997 ht rect leaky | ||
| SHARP |
DV3760H
|
Dead | S/c across lop stage; d601 1n4937 600v 1a s/c | ||
| SHARP |
DV3760 4BSA
|
Shuts down straight away at sw on | Replace loptx (hr 7559) plus r649 27r 1/2w, r637 27r 1/2w, r640 56r 1/2 w + 2 elect caps between base/emitter q1010 | ||
| SHARP |
DV3760
|
Tripping psu & led red/green flashing | C604 1000µ 16v in sec of psu | ||
| SHARP |
DV3760
|
Pic displaced 3" to right | R604 seems to be the cause (wrong value?) removing it centralised pic |