Repair Tips
Search:
Results: 88013
Results: 88013
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
PH21MG
|
Turn on after turn off | C826 of 47uf next to q802 | See also the w802 and the resistors that also cause this defect | Antônio Neto |
| SAMSUNG |
BE49N
|
TV turns on normally for a few seconds image keeps changing colors red, blue, green etc! | Cleaning flat cables, or changing them! If you don't decide to change tcon with flet cables! if it does not receive a ground fault on the main board | Eletrônica Manauara | |
| TCL |
32RS520
|
Lower LED current | Remove rv112(6.8r) and rv113(2.2r) and replace it with a 2.7r resistor. consumption will decrease to approximately 60% of the original. | Romar | |
| PHILCO |
PH40R86
|
Doesn't start | Ci ld7536 | When the TV board warms up, it works when turned off, it no longer turns on, the LD7536 switch was replaced, the defect was resolved. | TECCENTER |
| PHILCO |
PH40R86
|
Doesn't start | Ci ld7536 | When the TV board warms up, it works when it turns off and it no longer turns on. | TECCENTER |
| SEMP |
DL3277(A)
|
Plugs into the socket, the green LED is on and pulsating | Resistor 4r7 x 1/4w open position rp27 | Replace resistor rp27 and also replace diode dp9. | Phanton67 |
| SAMSUNG |
UN50NU7400
|
Blurred image | Unidentified | ||
| CCE |
TVP55
000 |
Broken vertical | Trimoti brξ01 =ξ00 ou 600 r | Replaced sleep.... | Jhone eletronica |
| PHILIPS |
14PT3131
|
Turns on and when the image appears, it turns off | Resistors 3443 and 3444 of 1r presenting 6r each | Replace | Eliel Magno |
| PHILIPS |
14PT3131
|
Turns on and when the image appears, it turns off | Resistors 3443 and 3444 of 1r presenting 6r each | Replace | Eliel Magno |
| PHILIPS |
14PT3131
|
Turns on and when the image appears, it turns off | Resistors 3443 and 3444 of 1r presenting 6r each | Replace | Eliel Magno |
| PHILIPS |
40PFH4100/18
TPN15.1 ELA |
The STBY LED turns on and does nothing else. | No reset voltage. | Substituir o ic u410 na main board. | jose almeida tavares |
| PHILIPS |
32PFL3404
|
It turns off in a few minutes, sometimes tsound is a beep from the speaker, it does not obey commands from the remote control or the TV. | Cause: accumulation of dirt/grease/moisture on the RF board (signal) | Clean the RF board with alcohol, pay attention to wsound the shielding is. | Jose Magalhaes de Oliveira |
| H BUSTER |
HBTV-32D03HD
|
When connecting to the network, the red LED lights up, when connecting to the button, the LED turns blue, the lamps blink and the TV does not turn on, all voltages are present. | After analyzing everything possible on the boards, I dismantled the LCD module wsound I found one of the lamp holders very open, causing poor contact. | Tighten (press with pliers) to close the lamp holders a little | Eletrônica Heinz |
| PHILCO |
PH200
|
Does not turn on, does not turn on standby, secondary power supply zero volts. | 22 volt zd1 zener burnt out. the zener burns out because of the bad filter capacitors tc9 -tc10. | If I helped, send a $5 pix... my pix 95679782200 | LOGANKLEITON |
| PHILCO |
PH43C21P
|
Main board defect | Power supply all voltages ok, sus ok and it didn't turn on, standby off | Ic u802 short replaced, tv ok | Valclei R. Ribeiro |
| SONY |
KDL46EX725
|
LED blinking and won't turn on | Remote control sensor shorted, just change it. | ||
| TOSHIBA |
42XV600
0000 |
TV inoperative without stand-by | Strz2589 e r851=AR,AR | Replaced, slept.... | Jhone eletronica |
| LG |
39LN5400
|
Does not turn on, nor does the ST-BY LED | C472 shorted | Replace.. | Maurilio |
| LG |
29FX5CL
CW62C |
Tsound is no sound | Capacitor c808 470uf 25v | Replace without measuring in the test, it says it's good | Paulistana pi |