Repair Tips
Search:
Results: 87707
Results: 87707
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP |
DL4061
|
no picture backlight on | smd capacitor cd6 on the screen board with leakage on the vcon board | just remove it from the plate and the picture returns perfectly | digitronica |
| SEMP |
DL4061
|
No normal backlight picture | Shorted diode on the vcom DL6 board | And just remove it and it works perfectly again | Digitronica |
| SEMP TCL |
50P65US
|
Duplicate picture, same picture on the right and left side | Main board Incompatible with t-con board | Transfer resistor R146 to R144 on the T-Con board | TAVARES |
| PANASONIC |
SA-AKX700
|
CD doesn't work | This sound arrived at my workshop with the following defect, I press the Open and Close key, it doesn't open, I opened the device, repaired it, the motors weren't working, I checked IC SA1466, it was shorted, I replaced it, resolved the CD, it was ok | Carlos | Carlos |
| PANASONIC |
SA-AKX700
|
Usb does not work A and B | I opened the device, analyzed the board, tsound were 2 shorted ICs, 5 SMD pins IC9002 and IC9003 code VBYQ = TPS2051C I bought Panasonic resolved USB A B worked perfectly | Andrei Electronics | Andrei |
| SANSUNG |
UN43AU7700
|
Completely stopped, not even standby | Screen drive board with shorted capacitor c203, however when trying to turn it on, the board was also inoperative, when checking it was found that two 13v fuses that came from the power supply were burnt, after replace them the TV started working again with shorted ceramic capacitor c203 | Replacement of c203 on the screen drive board and replace of fuses at the main 13v input, coming from the power supply. | Cosme |
| TCL |
55P635
|
Reduce LED current | on pin 02 of the OB3365QP ci increase the resistor to 60k. I put 120k resistors in parallel | sérgio | |
| LG |
21FU4RL
MC-059C |
The LED would light up, generate a high and turn off | After replacing several bad components, I tested the entire power supply, and finally I found transistor Q103 completely shorted, the transistor that feeds the varicap's 30volt line, I removed it, the TV remained the same | replaces the ic501, the TV was good thank GOD ----12/31/2024-----GOOD LUCK EVERYONE | Otacilio eletrônica G.G |
| PANASONIC |
L32U30B
|
TURN ON BACKLIGHT AND STANDBY BLINKING NON-STOP | CAPACITOR C7212 -120UF 450V | LOGANKLEITON | |
| SAMSUNG |
UN39FH5003G
|
TV turns on, backlight turns on and then turns off, won't turn on again. unplugging it after a while repeats the defect. | QM805 on power supply board - SMD NPN Transistor | Pardal-x | |
| AOC |
LE39D3330
|
No picture, client reported that sometimes disappeared and sometimes not | It arrived at the store with BL access, with all power supply voltages and 12v power supply for the screen, but VGH was missing | Solved with CI UP1 CM501 blower, after repair I also cleaned the flats. | Lucas |
| PHILIPS |
50PUG7406
|
Dead, no stand by. Arming the power supply, the voltages are all OK | Main board with 2 capacitors shorting out next to a 4r7 coil close to the CN701 connector | Remove and check if the short has disappeared, then replace them. SMD Capacitors C4328 and C4322 | World TV - Sorocaba |
| SEMP |
LC3246WDA
|
Turns on normally, lamp on without picture | Short on the tcon board, open fuse, 12v line, I injected 3v into the line, and an overheating SMD capacitor appeared, I tested it and it was the cause, TV working normally. | Remove the shorted SMD capacitor on the TCON board, inject regulated voltage and check self consumption. | SOS eletrônica |
| SAMSUNG |
LT24/27C310LB
|
The LEDs don't light up | TV arrived with sound and no picture, I immediately imagined it was the LEDs! I opened the display and the LEDs were 100%! Tsound was no voltage to power the LEDs! Voltage arrived at the SLC5013R ci (ic1701_ad) responsible for the voltage of the LEDs. | Replacing the SLC5013R ci | Rafael Sena |
| SAMSUNG |
UN40EH6030G
|
It doesn't turn on, and when it does, it turns off right away. | Transistor do POWER ON. | To test if the regulators are good, just release the Power On wire from the harness and see if the regulators on the board are working, if everything is working, without the power on connected the TV has to turn on, if it turns on and works perfectly, You have to analyze if it is not the Power On command transistor, tsound is one on the power supply and tsound is one on the main one, in my case, it was the bad main one, it is in position Q203, between the HDMI and the Optical Audio, just replace it and receive the Pix. | Eletrônica ATM |
| PANASONIC |
SC UA7
|
F61 when turning on the device | It doesn't turn on, it only stays on the display f61 | Claudemir Dias pestana | |
| PHILCO |
PTV50N10
|
THE PHILCO LOGO APPEARS AND ADD THE picture | CAPACITORS DEPLETED AT THE power supply 22uf / 250v | ANTONIO BATISTA - MAX SOM ELETRÔNICA - BH | |
| MONDIAL |
SK-06
|
Inoperative, does not turn on or charge battery | Switched power supply with defective Ci switcher. | As the original power supply is very weak, it was replaced for another more robust power supply of 1.5a at 12v, the ideal would be a 2.0a, but I didn't have it available, after replace the power supply, it started to work, but it did not recharge the battery, it was analyzed on the device's main board that the resistor R28 next to the Input Diode was open, it is a 10R SMD diode, which gives a sample of the input voltage to the Ci which recharges the batteries, after replace the resistor it recharged normally. | Eletrônica ATM |
| SAMSUNG |
LN32C530
|
Does not turn on - st-by off | Voltage enters regulator IC205 and tsound is no v-out, capacitor c268 is shorted. | replace.. | Maurilio |
| PANASONIC |
SA-AKX700
|
Sound does not turn on | TPS54240 and diode Code 36M9B I put the SS36 diode in its place | Resolved | Andre |