☰

Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search:
Results: 88072
Make Model Symptom Problem Solution By
SONY KDL-32BX325
LCD 		Turns on, works normally, but with the keyboard inactive, and, if you turn it off for a few minutes, and activate power via the keyboard or control, it doesn't turn on. It ONLY turns back on after being unplugged for a long time. Voltage 3.3 out at u701 with drop. Replace u701 = g1084-33 (3v3 regulator) NOTRYL
LG 21FU4RL
Very weak signal Z102 X102 Edval
TCL 32L2800
TPD.NT72563.PB772 		Decrease the current of the LEDs Resitores Replace the three resistors (0) connected in series to three (4r7) Multimarcas/Acarí
SEMP TV2090I
U14 		TV with flickering image, white stripes appearing, shaking for hours and then starting again Leaky 7805 voltage regulator Changing the voltage regulator 7805 ELETRONICA KLEIN
SAMSUNG T22A300
Standby LED flashing, +5v and +13v pulsing Ds812 diode in open power supply Replace with IN4007 Type F (High Frequency) Werner Schellmann
SAMSUNG HT-C550
Arming protection when switching on Capacitor c5n2 shorted on the power supply board Replace capacitor c5n2 (470/16). jean alves
ROADSTAR POWER ONE
RS4510 		Does not turn on just the fan Shorted electrolytic capacitor Cp11 470/25v Tec center
CENTURY C-1461 US
Turns on with noise C822 and c824 changed. MARCONES DE ARARIPINA-PE
CENTURY C1461 US
With noise at the power supply Swap c822 and c824 C822 and c824 replaced. MARCONES DE ARARIPINA-PE
LG 32LB9RT
Does not turn on, stand by LED is off TV doesn't turn on or standby, 3.5 v power supply is only 1.5v...disconnect from the main cable, power supply went up to 3.5v, I went to the main to look for a short, I found some 4.7 caps with high ESR, I changed them and nothing, I injected 3.5 v x 500ma and I didn't notice high consumption, the main LEDs lit up, I concluded that the main one wasn't defective, I went back to the power supply and found c510 and c506 (47u x 25v) with high ESR and completely dry, they measured zero with an analog multimeter, I just had to change it (mine conclusion and that the power supply did not supply the main consumption) Replace Maurilio
PHILCO PH28T35
I'm sound It arrived with the r621 (10r) open and capacitor c622 (220uf x 35v) inflated. Capacitor c630 shorted causing r621 and c622 to burn. I replaced the components and the TV started working again. CRISTIANO DONINI
PHILCO PB120N
It doesn't turn on and only the clock stays on Torque wrench I replaced the touch key and it was great alfredo nemecek
SAMSUNG 50PB560B
Has sound, no image All normal vs and va voltages, but without 18v and 5v on z-sus Z-sus board replacement Arnoltec
SAMSUNG UN55F8000
Restarting with smart logo Ci slc1013m with defect on the power supply board Replace of the same Arnoltec
MITSUBISHI TC -2098
TV does not turn on power supplys oscillating with noise tic tic tic type symptom of burnt horizontal th The problem was the primary power supply capacitor c 907 of 22uf x 100v exhausted After changing it, the TV works again ASSISTEC MANARI-PE
CCE HPS-1471
34BI 		When plugging it into the socket and pressing any button, the LED would flash and it would not be possible to start. Check primary, secondary, vertical, horizontal, and flyback power supply components In my case it was the fr401 (1r for 1w, close to the flyback), I replaced it and the TV finally turned on. Tiago C. Neves
PHILIPS 32PHG5813
No image with sound LED bar make the change and change the five current resistors until you get 1.2r Replace the LED and replace the value of the resistors and that's it orlando lott
PANASONIC SA-AKX100
Doesn't start Power supply with shorted 12v regulator Adapt a 12v 2a power supply in place of the ic1002 and run for hug Charlotniu
SAMSUNG UN40H4200AG
Does not turn on, stand by LED is off Ic 207 faulty dc dc converter Replace Maurilio
H-BUSTER HBTV 40D02
Popping sound (with pops) Spdif mode on Disable spdif mode in sound menu tchuba