Repair Tips
Search:
Results: 87722
Results: 87722
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV2084R
|
No picture, cracked board | Unit would turn on, hi v would come up, but no pix, blackscreen. push button controls inoperative. no signal on key scan lines.sleep light on. | ||
SONY |
KV2680R
|
No video, hi voltage ok, reseated connector a21 | Power would come on, sound ok, no raster, no control offunctions. traced problem to ic031 on x board, no 4 meg clock on pin 16.servicer had replaced crystal and chip. no ac ref signal on pin 16 of xboard, traced signal to a21, pin 1 on a board. signal | ||
SONY |
KV2781R
|
Shut down, resolder hlc l-515 | Upon turning set on, the unit would immediately shut downsubbing ref voltage and sensing voltage to pins 4 and 12 on ic301, setwould still shut down. froze different section of a board. when hlcgoes as frozen set would stay on. upon unsoldering hlc, f | ||
SONY |
SLHF400
|
Audio noise in beta hifi | Checked s/n at 400hz, was -68db. checked distortion at 400hz,1khz, 5khz and 10khz all read less than 2 1/2%. but a buzzing noise isheard also sounds like pumping. buzz can be heard on movie blue thunderwhen he sets his watch. also noticed buzzing on | ||
SONY |
MDRE248
|
Need p/n for earphone cord only | Need part number for earphone cord only. -hq comments: in order to get the cord you must order p/n x-2386-407-1which is connector item #3 in service manual. | ||
SONY |
XR66
|
No am | The unit had intermittent am operation. we found the 8v bussto the tuner to be loading down. the problem was caused by a defectivec516/47uf @ 10v. | ||
SONY |
SLHF400
|
No audio | No sound. | ||
SONY |
TCFX410R
|
Tension spring | Need head tension spring p/n 3-319-634-01 for tc-fx410r.kc shows none in stock or available. -hq comments: one piece of p/n 3-319-634-01 is being sent to you. | ||
SONY |
KV1311CR
|
No audio on tv, replaced ic-881 | No audio in tv mode. checked ic-881/pin 2, audio signalpresent. but ic-881/pin 1 no audio signal. | ||
SONY |
STRAV230
|
Low volume ac hum in output | Low volume ac hum in output. | ||
SONY |
XR740
|
Continuous auto reverse | Unit would auto reverse continuously. | ||
SONY |
MDRA25
|
No part number for divergence cord | Mdr a25 is a repairable unit, however no part number fordivergence cord. -hq comments: the cord is part of the headband assembly. it comes asone piece. | ||
SONY |
XR780
|
Part number missing | Protector (p/n 3-323-287-01) not called out on prints. also,many breaking. suggest fingers be made stronger. -hq comments: a service bulletin has just gone out regarding thisproblem. we will notify tokyo of breakage. | ||
SONY |
CCDV8AFU
|
Distorted pb picture due to drum/capstan problem | This unit had a problem where the drum and capstan motorswould run uncontrollably for 4-5 sec then the unit would shut down andonly eject would work. i found q508 open. this caused ic501 to get veryhot only in play mode. | ||
SONY |
KV1210U
|
Sub fbt | This sub fbt has instructions for installation but they are in japanese. i have a servicer that needs these instructions as soon as possible. -hq comments: we will publish service bulletin on this. | ||
SONY |
XR75
|
Missing part numbers | Need part numbers for spacers where they are located in 7iin supplement #1. -hq comments: see supplement no. 1 published in march 1984, spacers areitems #347 and #348 p/n 3-592-651-00 and 3-592-652-00. | ||
SONY |
XR780
|
Service manual errata | Service manual errata. s701, s702, s703 are incorrectlyidentified on page 41 of both manuals. s701 is tape direction switch.s702 is tape-in switch. s703 is tape-out switch. all are located on themd board. -hq comments: a service bulletin will be iss | ||
SONY |
KV1365
|
Unit dead, replaced t503 and fuse | Unit dead, f602 was opened due to t503 being shorted. | ||
SONY |
KV2601
|
No audio, replaced ic2001 | No sound. | ||
SONY |
CFD5
|
Wrong part numbers | Wrong part and p/n missing. parts list reference 395 shouldbe 305. ref 395 p/n 7-627-556-38 butt 2.6 x 4 (s). -hq comments: a s/b will be issued. |