Repair Tips
Search:
Results: 87707
Results: 87707
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
PSX30
|
Detection lever jammed | Scraping noise. cause is detection lever had been jammedunder protrusion on bottom of cam gear in shipping and was permanentlywarped. this was touching the top of the magnet ass'y on the motor shaft. | ||
| SONY |
PSX30
|
Incorrect spacing of cam and gear | The gear (reject cam) will not engage. cause is the spacingbetween the cam and the gear on the motor shaft was excessive preventingthe clutch assy to be pushed far enough to engage the teeth. the spacebetween these gears was visibly greater than on oth | ||
| SONY |
ICFC11W
|
L8 disconnected | No buzzer alarm. | ||
| SONY |
CF520
|
R401 opens | R401 opens and the motor will not run. | ||
| SONY |
TCM121
|
Belt jumps off motor | Belt jumps off motor pulley due to lubricant getting on belt. | ||
| SONY |
TAE5450
|
Transformer radiating 60hz | Hum in both channels. volume control had very little effecton control of hum. if volume control turned up, tone controls wouldeffect hum. | ||
| SONY |
STRV2
|
Blown transistors | Several units came in with blown power fuses. | ||
| SONY |
ICF7750W
|
Timer does not function | Timer will not cut off after activating. | ||
| PHILIPS |
14PV162
|
Calling installation menu | The installation menu is activated by the following procedure: - switch on the set by means of the stop key. - press simutaneously the cursor left and the cursor right key on the remote control. | ||
| PHILIPS |
14PT156B
|
No pic (field collapse) - sound ok | R3449 4r7 feed res to fop chip o/c - no other fault detected | ||
| PHILIPS |
14HT3303
|
Service code of the fm-radio tuner. | In the partslist of the radio-sp/ls-vbatt panel of the chassis manual l9h.2e, the service code of the fm-radio tuner item 1901 was not indicated. the service code is 9352 632 70112 | ||
| PHILIPS |
14CN3001/05
|
Int low contrast | Check preset res (chan scan) isn't shorting to crt aquadag | ||
| PHILIPS |
14CN2201
|
Dead - correct 100v ht on dummy load | Scan coils - had arced across rubber wedge | ||
| PHILIPS |
12TVCR240/05
|
St/by only - no line drive | Ug06b clamp diode leaky | ||
| PHILIPS |
12B312/15S
|
Dead. | Drys on sub pcb & bu type regulator. | ||
| PHILIPS |
10CX1120/05R
|
Power supply working but no line drive. | Changed the following t539 / t534 / r537 / r502. lopt faulty | ||
| PHILIPS |
10CX1120/05
|
Raster - distorted & no frame sync. | Ske bridge recy. | ||
| PHILIPS |
10CX1120/05
|
Dist raster & no field sync at sw on - clears aft 10 mins | Mains bridge rect int goes o/c | ||
| PHILIPS |
10CX1120/05
|
Dead - micro tms3757anl-10 | T273 bc557 s/c in av/rf sw cct also | ||
| PHILIPS |
10CX1120
|
Servicing the philips 10cx1120 | See tv mag jan 1995 |