Repair Tips
Search:
Results: 88147
Results: 88147
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| ELECTROLUX |
MG41R
|
When programming and trying to turn it on it restarts. (beeps back to zero) | Power supply without current, when trying to arm the relays it knocks down the 12v and 5v power supplys and the device restarts. | Coil l101 open, in the transformer primary. (2200μH) | mfelipe |
| TOSHIBA |
TV2999KMS
|
Vertical closed with blue line and turning off, | Vertical short and capacitor 448 close to the connector that goes to the deflector | Kel Araújo assistência técnica M6 | |
| SAMSUNG |
UN32J5200AG
|
Does not turn on standby LED off | Power supply goes into protection and does not power the main PCI | After analyzing the entire power supply I discovered the dm861c had a short and when replacing the power supply and TV it worked. | janilson |
| SEMP |
DL 3277I(A)
|
Green LED flashing after a while on standby | Dp9 changed | Replace without measuring | Paulo-ps Eletronica |
| TOSHIBA |
TV2999KMS
|
Vertical closed with blue line and turning off, | Vertical short and capacitor 448 close to the connector that goes to the deflector | Kel Araújo assistência técnica M6 | |
| SEMP |
1490
|
Turns on the LED and turns off | After checking all the parts that gave this symptom such as the capacitors, c419, c884, c435, c810 and c878, the cause was the flay back replaced and resolved | ELETRONICA PUBLISOM DE NATAL RGN | |
| SONY |
KDL-40NX705
|
Turns on shortly after turns off and stand by LED flashes 6 times | 01 0.5 fuse open at the power supply, close to the back light power connector and 7 shorted bar LEDs. | I replaced the fuse and the LEDs, I couldn't find the bars, I only replaced the defective LEDs. | ALEX LOPES |
| CCE |
HPS2991FS
|
The panel light takes a little while to flash, the light is not on continuously but flashes very weakly, b+ is very low and varies, q404 and q405 are broken, but I don't know if the customer shorted out these protection transistors or fpi because of the defect at the power supply. | The cause was the c816 470uf by 400v completely exhausted! | It was just a matter of changing it and the power supply returned to present the stable and correct voltage, the 2 protection transistors q404 and q405 were also replaced, which I don't know if the customer accidentally shorted these 2 transistors, because I think it's difficult for the power supply's main capacitor to be exhausted, cause these transistors to burn. | Fernando Elêtronica Millenium |
| SAMSUNG |
LN32B450
|
With sound without image | Thanks to my friend roberto reparas for the tip, to put an r=4.7 k between pins 16 of the ic without 2006 when inverting the socket, thanks dear, thanks | Thanks to my friend roberto reparas for the tip, to put an r=4.7 k between pins 16 of the ic without 2006 when inverting the socket, thanks dear, thanks | |
| AQUARIO |
CA 40
|
Passwords | 2668 3266 1234 | To reset | Eletronicaaeb |
| TOSHIBA |
2934
|
Yellowish screen missing blue color | Zd204 diode in the rgb line | ezioeletro@hotmail | |
| LG |
21FU1RL
|
Vertical closed | All components in the vertical sector, deflector coil and vertical outlet were tested, but nothing was found. checking the micro pins does everything, and on pin 16, tsound is a capacitor c512 / 0.47 pf, this capacitor was open. | Capacitor replaced c512 / 0.47 pf | Carlos Alberto (ELETRÔNICA BATURITÉ) |
| LG |
21FU1RL
|
Vertical closed | All components in the vertical sector, deflector coil and vertical outlet were tested, but nothing was found. | Carlos Alberto (ELETRÔNICA BATURITÉ) | |
| SAMSUNG |
PL42A450P1
|
No image | Tsound was no vs voltage on the y-sus board and z-sus board, SMD capacitor (c2058) short circuited on the controller board, also blowing the fuse. | SMD capacitor (C2058) replacement or removal and fuse replacement. | Carlos Alberto (ELETRÔNICA BATURITÉ) |
| PHILCO |
TP-1452N
|
Power supply does not arm, LED flashes (activating protection) | Fly-back damaged. uses ov2094/d1-c. but I used the ov2094/d1-a, although different, it works the same. | Replace the fly-back remembering to adjust the focus and screen potentiometers at least before turning it on for the first time. | |
| PHILCO |
PH32F33DG
|
Piscando led standby | Update software | Downloading the update from the Philips website means updating. | Naldo Lima |
| LG |
42CS460
|
TV turns on, but tsound is no sound or image, the backlight is on. It works with keyboard and control commands. | 2.5v regulator near nvram, tsound was no voltage output. Tsound was no short in the line. | Replace | joaomvjr |
| SAMSUNG |
T24A550
|
Sem os 5v do stand by | Zdm801 in the power supply primary with leakage | I put a 9.1v x 1/2w zener in its place, also check zdm802 | SILNEI |
| SONY |
GPX7
|
Please wat | Placa pricipal | Main pci replacement | Cabeça |
| SAMSUNG |
UN-46FH5003G
|
Blinking LED does not turn on | Capacitor without capacitance | Replace cp 812 22x50v power supply | Laercio umuaramapr |