Repair Tips
Search:
Results: 88148
Results: 88148
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MAX-A55TD |
SAMSUNG
|
Sometimes it turns on, then it doesn't turn on again, only with the panel LED on, if you remove the cable from the socket it won't work again | D06 in4148 that feeds pins 13 and 43 of the micro controller. | Just remove it and leave it without it, the voltage is 3v and it works great. | guinga sdia goias |
| LG |
50PJ250
|
Shorted power supply board, activates the relay and in a matter of 2 seconds it disengages. with standby on | Cold soldering | Breno gonçalves | |
| PANASONIC |
TC 29FX30L
|
Turns on and then turns off | Shorted diode d511 between flyback and vertical | After the replace everything was ok. | George Pontes |
| SAMSUNG |
29 TUBO
|
Colored scratches on the top of the screen, starts with few scratches and progresses over months. | Capacitor c304 | Replace capacitor c403 100μF 50v | Renato RPA SJC SP |
| MICROSOFT |
XBOX ONE
|
The power supply turns on the white LED, but then turns it off | Insufficient power supply for the power supply drivers, low value electrolytic capacitor, near the STB power supply driver IC altered | Replace the two electrolytic capacitors close to the stb power supply ci | davi.sls |
| LG |
RP-21CA85
MC-83C |
TV arrived with little contrast, I checked the power supply and found a defect in the d502 power supply close to the r550 | Oxidation | D502 I put 1n4148 and run to another | eletronica miranda |
| SEMP TOSHIBA |
DL3971(B)F
|
When you plug it into the socket it turns on and the channels work normally if you turn it off on the control or keyboard it turns on but the channels don't work so you have to unplug it again | When it doesn't work, turn off the channels, leaving them on standby, if tsound is 1.8 at the u206 output and just remove r10 of 100Ω | falcon eletronica | |
| SAMSUNG |
UN46D7000LG
|
It doesn't turn on, but it hits the relay. | If we disconnect the cable that goes from the power supply to the main, the TV turns on and the LEDs light up. then the main board or tcon is completed. | I disconnected the cable from the tcon and the TV turned on, it turns out tcon, but in this case, oddly enough, tsound was bad contact in the flat cable fitting on the tcon, it actually turned off the TV as it moved in this fitting, I cleaned it with propyl isodine and eraser and just ran for a hug. | MIGUELTV |
| PHILCO |
PH42E53SG
|
TV doesn't turn on, doesn't have 3.3 volts | Zener diode d 203 of 18 returns short | multsom | |
| PHILCO |
PH400
|
Low sound, but everything works. You can barely hear it, even with the volume turned up to maximum. | In this case it was IC8, an 8-terminal IC, close to the DVD motor connections | Replace the ic8: f16-100 hip | Romildo Behrend Schwartz |
| PHILCO |
PH400
|
The device doesn't turn on, it just turns blue on the front, on the volume button, but it doesn't activate anything. | It was discovered that it was a diode, which is on the IC side of the DVD motor drive, wsound tsound are 3 in the middle of 2 larger transistors: d33 | Replace the d33, even if it is good in terms of measurement | Romildo Behrend Schwartz |
| PHILCO |
PH400
|
The blue volume LED keeps flashing and the device does not turn on. the 5v and -21 power supply is oscillating, below what it should be. | After much research, it was found that the 33nf capacitor cb8 was responsible. | Replace for another good one, even if it doesn't show a defect. It is close to the photo coupler and the DVD motor connections. | Romildo Behrend Schwartz |
| PHILIPS |
20PT524A
|
I'm sound | Microns that are on the audio board. | Luan LG Philips | |
| HBUSTER |
32L05
|
With sound without image | R116(AR),117(ARAR),118(QARA),119(1R) | HP ELETRONICA | |
| LG |
50PN4500
|
Turns on and returns to standby in 3 to 5 minutes | Dz352 was open on the power supply board (det_17v protection) zd352 on smd was written tf 3 | Replace dz352 | eletronica valdecir |
| MIDEA |
MTAE21
|
Dead | Ci lnk364pn and 2.2mh inductor open | Replacing them | Rodrigo V F |
| CICLOTRON |
DBK6000
|
Left channel burned out without sound | 1r of 47r open2transito shorted one 2sc4793and the other 2sa1837 | I put the 47r and the 2transisto the ones that were in it are 2sc4793 and the 2sa 1837 as I didn't have them I put the 2sc2336 2sa1980 which replace 2sa1006 2sc4793 I replaced the 2sc2396 and that's it the amplifier was very good again | Reis eletrônica |
| SEMP |
TV2134
SK11 |
Greenish image without normal color | Q501bf422 | Replace the transit and the TV is good again | Reis eletrônica |
| SONY |
MHC-EX9
|
Turns on and goes into protection: | C452 short/leak - q451 filter (3.3v reg - panel) | To replace | GSM |
| SAMSUNG |
LN32C350
|
Intermittent volume increases and decreases | Clean the silicone heatsink on the underside of the main board with isopropyl alcohol. | MARIANO |