Repair Tips
Search:
Results: 88161
Results: 88161
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| TARAMPS |
DSP3000
|
Does not turn on, only LED | When checking, I found the r59 4r7 burned and the c.i drive of the ucc27324 power supply was also burned, a difficult component... with a lot of searching I found an equivalent mc33152 and it worked perfect. | R59 4r7 e c.i 27324 replaced by mc33152 | Sylvox |
| TOSHIBA |
TV1451
|
Very low low sound | C613 220x25 low capacitance at 90 nm | Replace it and go for the hug | orlando lott |
| PHILIPS |
FWM582/BK
|
No audio at subwoofer output | 47x63v c423 | Capacitor replaced | Artagnan |
| TV LENOXX 2100B |
2100B
|
Popcorn cap. 4.7x160 c444 | Replace capacitor c441 | regis eletronica | |
| CCE |
D46
|
Flashes the lamps and turns off | Ck15a next to the high voltage connector on the power supply | Adrian Chapadão do Céu | |
| SEMP |
TV2051NAV
U18 |
Right side a little closed | C 47.p 250 | And just replace | tony |
| SAMSUNG |
LN32B350F1XZD
SQ01 |
TV doesn't turn on, just stays on stand by | C1045 on the PCI of signals coming in short | C1045 replace | PAULO PINHO |
| SEMP TOSHIBA |
1451NAV U18
|
Very low sound, you could barely hear it just put your ear to the speaker | Capacitor c 613 220uf 25v | Capacitor c 613 220μF 25v | OP Eletrônica |
| TOSHIBA |
TV-2015N
U18 |
Low sound | C635 and c613 of 220ufx25v exhausted | Replace them with new ones | EK Eletrônica |
| LG |
LM-U1350A
|
Low sound at the exit | Strx6759 from burnt amplifier power supply | I just replaced it and it was new!!! | ELISEU |
| PHILCO |
TPH21M SS
|
LED blinks but does not turn on low 20v power supply | Saida vertical ic301 | Replacement | ERIVA |
| SAMSUNG |
2033M
|
Turns on and off 3 seconds after the screen turns on | Lamp protection | Turn off protection. on the board that uses the fan7317 ci connect pins 4,6,15 and 17 to a 560Ω resistor and connect to ground | Cláudio A. |
| PHILIPS |
29PT558
|
Vertical at the top with retrace and skipping the retraces on top of this fold | All components were good. I just resoldered the ci terminals and it was ok | ||
| PANASONIC |
TC-L42E5BG
|
It doesn't turn on, nothing lights up, or the green LED flashes and then the red LED flashes. | Cap change. 470x25v 12v line by 1000x25v, power supply board. | The 5v voltage kept oscillating, and the TV would not start on stand by. | joaomvjr |
| SEMP |
TV2134
|
TV turns on and off then, image appears and then turns off, after so much insistence the intermittent relay kept hitting | R609=36k the same was changed measuring 67k | I replaced and ran to another one | Antonio Carlos (Eletrônica Renascer) |
| LL |
LX60
|
Dead | R25(330k) open | William Tec | |
| TOSHIBA |
TV2934
|
TV turns on and off, when the screen increases, a line appears in the middle of the screen as if it were vertical | D306 open | Replace the d306 | Emerson |
| PHILIPS |
40PFL3805
|
Turns on the image and then turns off | Resistor r515, r516, r517, r518 with changed values. | Measure and replace any that are altered. | GL Eletrônica BH |
| PHILIPS |
PHILIPS
|
Turns on the image and then turns off | Resistor r515, r516, r517, r518 with changed values. | Measure and replace any that are altered. | GL Eletrônica BH |
| PHILIPS |
32PFL5403
|
Does not turn on, LED flashes 4x | 2p34 smd cap short | JOAOMVJR |