Repair Tips
Search:
Results: 88176
Results: 88176
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS-2971
|
Filament lights up and goes out a few times and the TV doesn't turn on. | Falta da power supply de 8, sv | Open resistor fr431. | Persio (TVCompany) |
| CCE |
HPS - 1403
|
Black and white image | Cristal x 502 ( 3.575611 | Replace the same | BARRETO CRUZ |
| CCE |
HPS - 1403
|
Burning fuse | Capacitor - 821 (561/lsk) | Replace the same | BARRETO CRUZ |
| SEMP TOSHIBA |
G74/313D
G74/313D |
Blurred image | Tube socket. | Replace the same | BARRETO CRUZ |
| LG |
21FU6TL - L4
|
Doesn't start | Ic - 804(kia -78ro9pi) | Replace the same | BARRETO CRUZ |
| LG |
21FB32
|
Burning horizontal output d2627 | Changing the flyback and replacing d2627 with bu2508dx, use a good heatsink and smile happily | Changing the flyback and replacing d2627 with bu2508dx, use a good heatsink and smile happily | Joao da Silva |
| SHARP |
C 2057
|
Flashing image | TV turns on, image appears and disappears, flickering | Replace the 220/160v electrolytic capacitors c 725 and c727 | |
| PHILIPS |
14PT112A
|
It doesn't start, LED flashes straight on. | C2447 [470 pf/ 2kv] shorted. | Altevir Lima [Valparaíso Eletrônica/ Ananindeua - PA | |
| PHILCO |
PCS-2700
|
Turns on normally for approximately one minute, then saturates red. | At first I thought it was the processor since the last pin measured 3 volts and was supposed to measure 0 volts and this corresponds to the color red. but I bet on memory. | I replaced the memory with another one and the problem was solved. | ORCLEY |
| GRADIENTE |
TV-2922
|
Burning bu2508ax | According to the diagram, the bu2508dx goes, but on the TV it goes the ax, but when you put the dx it boils | Put the bu2508ax, logical after reviewing the usual... | stevesandrei |
| NKS |
PCD3005
|
Device does not turn on cdmp3 | Cold soldering | Touch up solder on the power supply board | danielpauly |
| SAMSUNG |
CN3383
|
Vertical closed, just a scratch | Resistor 307 de 51k 1/8w | valter | |
| CCE |
29USP
|
Image with black line changing color and blinking! | C310 e c311 smd (470pf) | Replace and run for the hug | Rafael Feitosa |
| CCE |
29USP
|
Greenish screen with line of retraces | Fr901 | Replace of the same | Rafael Feitosa |
| GRADIENTE |
TF2140
|
TV with a symptom that looked like it had a burnt horizontal output, but when carrying out tests, it was clear that tsound was a blown capacitor. (c709) | A capacitor (c709) literally burned | In my case, I removed it and turned on the TV, but of course you have to check the entire power supply and horizontal stage | Adriano SB |
| ELSYS |
2.0 BLACK OU PRATA
|
Does not tune h or v polarization | Replace q 102 e q 105 | Just measure the voltage at the tuner output and check that it has 14v and 18v. | |
| PHILCO |
PH200
|
It turns on, but the display is off. It only has the volume button on. | U9. change and run for the hug | ||
| PHILIPS |
21PT9467C
|
Cushion effect | After replacing q303 and c327 the device is still defective | L-301 | ELETROBRITO |
| SEMP |
2051NAV
U18 |
Rosy sound but when you change channels the blue is superimposed on the image. Tsound is no 18 volt voltage on pin 9 of the audio IC | Remove from the kinescope board the q906 is an smd transistor and leave it without it | RONNYSK8 | |
| PHILCO |
PCM2046
|
Screen with shaking and crooked image with a shadow outlining people | Capacitor 915 1000 x 35 and saw 201 filter and small electrolytic capacitors of 2.2u 2 10u around the handyman | These two components must be replaced and the small 2.2u and 10u caps are just three | lucas |