Repair Tips
Search:
Results: 87715
Results: 87715
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
32PFL4007D/78
|
Blue fabric | Short on tcon, several caps. measuring short and responsible for everything was the c95, hope to help someone. | Changing the cap. c95 | Arimateia |
| SAMSUNG |
UN40ES6100
Y3ER3XCC10718X |
Flashing back light, only this power supply oscillating! | L9191 shorted | Replace the l9191 coil (lpd6d-dry ks-1220aak, swipe shape! You can replace it with another one from the same circuit with a different number and pinout! | BRAMBILA |
| SAMSUNG |
PL51F4000
|
Restarting | 3v3 processor power changed to 3v5. | Remove r817 and put a jumper in place, reducing the output voltage to 3.17v. | Valdecir Schena |
| PHILIPS |
DVP3005/BK
|
It only had the STB LED on, it wouldn't turn on at all | 1y faulty oscillator crystal was replaced and the device worked perfectly again | ||
| SONY |
KDL-32R435A
|
Turns on, appears soon and turns off, | Flat display strip with poor contact, "this TV model keeps turning off if the display strip is not connected". | KLEiTON | |
| PHILCO |
PH 21 MSS
|
When plugging it into the socket and pressing the power button, the LED flashes and does not turn on. power supply with +b oscillating between 23 and 27 volts | Diode fr 104 in position d 818, shorted | Replace it and check the capacitance of the c 827 capacitor (25v/1000μF). | RENATO- Podium eletrônica |
| SAMSUNG |
LN37C530
|
Does not turn on, only in STB | Regulator h, cv | Equivalent, replacement, replacement of the aoz1031ai, I replaced it with the aoz1073pi and it worked well, all that replaces is the switching frequency, but nothing significant. | Davi.sls |
| PHILCO |
PH1700BT
|
Turning off by itself, sometimes it takes a while to turn on | Change the micros! the defect is just one, but I always change them all! | Replace all computers (rodrigo cofferi) | Rodrigo cofferi |
| PHILCO |
TP2010
|
Does not light up or standby +b with 45v all other voltage absent or low | Tl431 just change it which regulates the power supply | Replace tl431 | Beto2828 |
| PHILIPS |
49PFG5001/78
|
Turns on normally in seconds turns off | Defect in memory removed and rewritten resolved | Luis Aquino sparapan | |
| SEMP TOSHIBA |
LC3246(B)WDA
|
TV does not tune channels or has difficulty tuning air channels | Ceramic smd capacitors c114,c116 next to ci n100 | Eletrônica JM/Júlio | |
| LG |
14SB1RB
|
The TV does not adjust the contrast but you can see the image but with little contrast. | R406 close to 240km flyback | Replace it and you will see the perfect image very clearly. | SW Eletrônica |
| SEMP TCL |
32S6500S
RT41PB-AG |
TV with sound without image | Burned out led (1 led) | Replace of the complete, new bar kit and chain reduction. I replaced the two power supply resistors with just one whose value was 0.144ma. | Cesar762 |
| LG |
43UN7310, 49UN7310, 50UN7310, 55UN7310, 65UN7310, 70UN7310, 86UN7310, 55UM7470
LJ20 / LJ9 |
Failure to turn on/ the vesses only the logo appeared and nothing else/ the vesses did not turn on stand-by light/ and the vesses just blinked stand-by | Two changed resistors | On the right side of the 3.3v regulator IC2310, two resistors, the upper one r2411 of 39k, and the lower one r2410 of 102k were altered. r2410 measuring 100k enough to cause the problem. | Rafael Nunes BOMBINHAS |
| LG |
43UN7310, 49UN7310, 50UN7310, 55UN7310, 65UN7310, 70UN7310, 86UN7310, 55UM7470
LJ20 / LJ9 |
Failure to turn on/ the vesses only the logo appeared and nothing else/ the vesses did not turn on stand-by light/ and the vesses just blinked stand-by | Changed resistor | On the right side of the 3.3v regulator IC2310, two resistors, the top one r2411 39k, and the bottom one r2410 were altered. | Rafael Nunes BOMBINHAS |
| ELETROLUX |
MEF30
|
Microwave does not turn on, power supply defect. | Main board defect, power supply circuit leak in the smd c105 capacitor, simulating failure in the pwm oscillator ic100, 1uf capacitor is between pins 1 and 7 of the reg with an approximate leak of 200r | RNSPTEC | |
| PHILCO |
PH48
|
Turn on the LEDs, with sound but no image | Cap shorted on the t-com board in my case the c09 | Rodrigo cofferi | Rodrigo cofferi |
| STREAM |
BM32L81
|
Tsound is no pilot light or switch on | Shorted smd pc6 capacitor | Replace for another 0.1μF | Hugovitch |
| LENOXX |
CA-304
|
Turns on, works, but no sound | Capacitor blown, sound output ci burnt. | Replaced the 100μF x 16v capacitor, the xpt9911 ci and a 4.7r resistor that goes between pins 1 and 12 of this ci. see her schematic on this site. helps a lot. | Pixel Assist |
| AOC |
D42H831
|
After a while on | Test the 3v3 voltage regulator ic 701, when working it measures 4v when it doesn't work it stays at 1.8v, just change it and run for the hug. | Eletronica Oliveira |