Repair Tips
Search:
Results: 88011
Results: 88011
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| BEDIN |
BS6000
|
Receiver giving normal audio but no image | Ez | Replace the e3 220μF 16v capacitor and that's it, the image returned normal. | Sinailson furtado |
| SEM TOSHIBA |
2959JFS
LEM10 FS8 |
Low sound | Sem som c 611(0,1/50v), c623(2,2/50v), c624(2,2/50v), c636(47/25v) e c637(47/25v) alterados | Silent capacitor replaces c 611(0.1/50v), c623(2.2/50v), c624(2.2/50v), c636(47/25v) and c637(47/25v) | Roberto Televídeo |
| PHILIPS |
40PFL3805
|
Burst 24v power supply | In the absence of the ncp1207, I researched similar ones, the fan5571 was pointed out, which I didn't have, I looked through my scrap and discovered the ncp1200d6, with 200d6 written on its body, all I had to do was place just a 10k resistor between pin 1 and the ground, eliminating the other components that had | Davi.sls | |
| TOSHIBA |
40L2500
|
The standby LED does not light up (does not work) | Swollen capacitors. and n806. | Replace capacitors and ci rt9889 (1v15 core) | BRITO |
| LG |
55LA6210
|
White screen. | Sound on board t-com tps-65198 | Replace the same and a hug!!! | Boleia |
| AIWA |
ZR900
|
Plays the CDs normally but sometimes it opens the tray alone if it is stopped without any function then it stays in direct shelter | Micro keys on the CD plate that is on the CD mechanics, change or clean them | ||
| AIWA |
ZR900
|
Complement no sound on the tape deck b even with two speakers and increasing the volume to maximum, the tabe a only has sound on one normal channel, the other works very quietly | Defect in ic302 (cxa1553p) just change it and go for the hug | ||
| PHILIPS |
32PFL4007D
|
Turns on and gets stuck on the logo | Memory software is corrupt | Update via pendrive. After downloading the update, plug it into USB1 and turn on the TV. | SilvioSantosCTV |
| SEMP |
2177
SL11 |
Hitting weak relay and high power supply. | R878 amended. | Romar | |
| AOC |
LE32S5195/78G
|
LEDs light up but no image, as if the TCOM had burned out | I cut 6 tracks that go to the display screen flat, tracks 14 to 19 from left to right and it worked | Cece eletrônica Brumadinho MG | |
| LG |
42LG30R
|
Red image, menus with ok colors | Rewrite the ic802 eeprom | Resistronic Resende | |
| AIWA |
ZR900
|
Carrocell doesn't spin and CD doesn't work | 33r resistor open or changed, the value must be 33r, located on the CD board and connected to the 11 or 12 v power supply | ||
| AIWA |
ZR900
|
No sound and all functions | Transistor a114 defective it releases voltage to the 60 v power supply relay if the power supply is not recognized at the beginning of the device fertilization it will not produce sound | Just replace it and that's it | |
| LG |
42PB2RR
|
Stand-by LED on, but does not turn on, neither on the button nor on the cr. | C-837 22uf x 16vdc smd replace is between ic900 and ic800 | I was very happy because I was accurate with it, I hadn't found anything online about this defect. | robusto SCINFO-RJ |
| SEMP |
40L2500
|
The red LED comes out but does not turn on, 5v oscillating, replace the bloated capacitor and the n807 | If when you press power the 5v on the n807 drops and keeps oscillating, replace the n807 | Rodrigo cofferi | Rodrigo cofferi |
| LG |
60UM7270PSA
|
Flashing, no image, no characters, normal sound. | Checking the t-con board on the back, under the processor and under the ic u300 (5567s) tsound were signs of overheating. When heating the IC, the board returns to 17V voltages | IC U300 (5567S) replacement or replace T-CON board. | World TV - Sorocaba |
| LG |
50PB650
|
Doesn't start | Defect on the main board to make auto gen and just turn off the power supply on the main board and jam the auto gen on the controller board and release the lvds cable | Replacing the main board | orlando lott |
| TCL |
55P725
|
The backlight doesn't turn on, but the bus is fine. | AD602 diode shorted. (mbr3200) | To replace. | Persio (TVCompany) |
| PHILIPS |
40PFL3605
|
Turns on stuck at the logo, sometimes it even works, but if you turn it off it won't turn on again | Corrupt nand flash memory, does not accept usb update. | Rewrite or swap nand memory | World TV - Sorocaba |
| SAMSUNG |
UN50AU7700G
|
Does not turn on, no stand by | Short capacitor on the main board, you have to remove the heatsink | Replaced shorted capacitor and 13v input fuzistor. injecting 3ah into the 13v input helps to find it. | ANTENISTABNU |