Grundig Repair Tips

Search: Grundig
Results: 948

Make	Model	Symptom	Problem
GRUNDIG	GT2103	Hum bar	Mains smoother 47µ 385v o/c
GRUNDIG	GT1401	No sound or pic	5v supply missing because d114 cathode no soldered thro' print
GRUNDIG	GSC700	Int smeary flat picture.	Luma delay line leaky.
GRUNDIG	GSC200 CHASSIS	No sound or picture, led displays not lit.eht at 18kv.	C2607 in relay pcb sced.check also d334 and d335 in tuning module as in one case they were found to be sced together with c2607.
GRUNDIG	GSC200 CHASSIS	Black screen, eht at about 18 kvs.	Change di511.
GRUNDIG	GSC200 CHASSIS	Arcing in picture. reduced width with torn edges.	The ho transformer has a built in fuse holder which houses a 50ma fuse. (connected in series with the high tension cable). replace the fuse and clean the contacts.
GRUNDIG	GSC200	No results.	R607 o/c , r621 o/c , if goes agn few hrs later di2502 4.7v
GRUNDIG	GSC100	R607 - repeated resoldering of r607.	Di2502 ( 4.7v ) zener.
GRUNDIG	GSC100	No frame.	Di447 ( 1n4007 ) and/or tda1170.
GRUNDIG	GSC100	Line break up.	C2502 (100uf, 16v) on eht control rule build pcb.
GRUNDIG	GSC100	If eht is very high	Check di508 is open
GRUNDIG	GSC100	Frame - bottom foldover - cramping at top.	R2522 ( 2.2k ) goes high.
GRUNDIG	GSC100	Dead.	Di511 or c2502 (100u f, 16v) on eht control rule building pcb.
GRUNDIG	GSC100	Dead.	R607 o/c , faulty thyristors , insulation in line o/p stage.
GRUNDIG	GSC100	Dead - blowing 3.15amp fuse.	Eht cap jumping across to degaussing coil.
GRUNDIG	GSC100	Dead - blowing 3.15 fuse - intermittently.	Eht cap arcing.
GRUNDIG	GRT550	Dead.	T661 ( s668t ) faulty.
GRUNDIG	GCS100	Dead - blowing fusible resistor.	Insulating pad under ty501 leaky.
GRUNDIG	G1000 GT2103	Bright raster with fb lines	R315 10r near loptx o/c - supplies volts to rgb
GRUNDIG	G1000	Unfocused 6 inch wide band down screen only	Line freq twice operating freq - cannot be adj - ic500 micro faulty