Lg Repair Tips
Search: lg
Results: 4876
Results: 4876
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
20CB62
|
I'm here | C - 607 | Replace the same. | BARRETO CRUZ |
LG |
20B85
|
No width. | Shorted deflector. | Replace it. | BARRETO CRUZ |
LG |
21FS4RLG
|
Tube without image, writing without tension because of the tube!!!!! | Close a short from the damper diode (+) to/the scrum, that's right!! it will clean inside the tube and it works. OK | I did this and it worked, try it and you're lost!!!! | ELIZEU- Brasilia |
LG |
CP20J52A
|
LED blinks, blinks and does not turn on | Era c801-100mf-35,c826,c850-470mf-16 | I replaced and went for the hug | ELETRÔNICA MELO BOA VIAGEM-CEARA |
LG |
20CB20A
SC-023A |
Retraction on the image. Even if you reset the screen, there is still a brightness on the screen | Open track next to the 180v pin | Make a jumper on the f.b pin to the 1 oh resistor | DERLI SOUZA |
LG |
21FU6TL
CW81B |
Start and cut before accessing the screen. | Measuring the +b I noticed that it went to 112 volts and then dropped to 75 volts on the flaybk pin, I released the flay pin and it remained the same, the cause was the Q16 with a leak in the protection line, I released its base and the TV turned on, that's it So, let's come together and send tips, the world is for everyone. | I replaced the Q16 and everything went well, all I had to do was pick up the bμFunfa and have a cold skol and a quick hug. | |
LG |
29FS4RLG
|
Swapped colors | Crystal x01 | paulo masao | |
LG |
21FU4RL
|
It turns on sometimes with difficulty +b with 100v (110v normal) when activated to turn on, voltage in the driver remains 0v. | Replace power supply regulator strw6554a. | @gepe | |
LG |
21FU1RLG
|
Does not turn on stand-by | Diode 874 shorted, ic 806 shorted | daf eletronica | |
LG |
CP29C85
|
The TV turns on, it says it's going to turn on, but it doesn't turn on. +b starts and then falls all three. good... all power supply capacitors are good. | Cause c404 100uf x16v open is next to the seletronic | ||
LG |
29FX5CL
|
Burning horizontal outlet | Fly back then do a review r404-d404-r843-c406 and c407 | HP ELETRONICA | |
LG |
21FS4RLG
|
Photo coupler ic 802 | |||
LG PLASMA |
TODOS
|
Screen flickers (black or bright dots appear on the screen | Loosen and reconnect the y-sus board connectors, if the symptom persists | Y-sus plate replace | Vosdor |
LG PLASMA |
TODOS
|
Stained screen that changes position every time you turn on the TV | Loosen and reconnect the y-sus board connectors, if the symptom persists | Y-sus plate replace | Vosdor |
LG PLASMA |
TODOS
|
Blurred image, image looks like a drawing | Loosen and reconnect the main board connectors if the symptom persists | Replace main board | Vosdor |
LG PLASMA |
TODOS
|
Blurred image, image looks like a drawing | Loosen and reconnect the crtl board connectors, if the symptom persists | Replace crtl | Vosdor |
LG PLASMA |
TODOS
|
Blurred full screen | Check the z-sus board settings if the symptom persists | Z-sus replace | Vosdor |
LG PLASMA |
TODOS
|
Horizontal strip | Loosen and reconnect the y-drive board connectors if the symptom persists | Replace y-drive | Vosdor |
LG PLASMA |
TODOS
|
One or more horizontal lines | Loosen and reconnect the y-drive board connectors if the symptom persists | Replace y-drive | Vosdor |
LG PLASMA |
TODOS
|
Vertical strip | Loosen and reconnect the crtl board connectors, if the symptom persists | Replace crtl | Vosdor |