Lg Repair Tips
Search: lg
Results: 4875
Results: 4875
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
LG |
47LA6130
|
No image just blacklight on | Cabo flat tcon | Good cleaning and 2 layers of durex, it was fine, good luck | Jhone eletronica |
LG |
43UJ6525
|
Takes time to connect (slow processing) and does not tune channels | Burnt varicap | Tuner/varicap replacement ebl61840501 | Tulio Moreira |
LG |
42LG30R
|
Standby passes to blue and does not turn on. without 24, 12 and 16v | Rl-101 with open bonnet. | XANDARE | |
LG |
29CC2RL
|
No audio.. | 808 capacitor with little capacitance. I also replaced the c 422 (4.7mf x250v), as it was slightly swollen and had low capacitance. | flavio | |
LG |
32PC5RV
|
Green LED flashes 10x and turns red | Replace r801 remove c804 | JOSESOMMAIOR | |
LG |
29FX5CL
CW62C |
Image closed on the sides 3cm | C314 (4,7x160v) | Cleber | |
LG |
42PJ350
|
Gives sound. tsound is no image | All panel voltages ok, 15v@18v ok. tcon led off. | With the TV on, I tapped the tcon's ic xd and the image appeared. bga ic xd failure. replace tcon | Emoniz |
LG |
21FU4RLG
|
Cushion effect | In my case, I noticed the ci tda8145 was very hot. I changed it and everything was resolved. Attention! It may not always be the problem. It's worth checking the components connected to it as well. Hugs! | D.S.E.Eletronica | |
LG |
773N
|
Monitor does not turn on and the power LED does not light up. the 5v supply is missing | Change c954 1000µf/10v connected to d942 on pin13 of FB | Mancarra MStronica | |
LG |
42LG60FR
LP81A |
Hdmi 2 and hdmi 3 have no sound, only image | Identified double burnt diode on hdmi 2 - (d300 - kds184s - b3 mark) | Replace the d300 diode (d300 - kds184s / b3 mark) on the hdmi2, and it was also necessary to rewrite the ic301 and ic303 - 24c02bn memories with the same content of the ic300 which is from the hdmi1 port that was working. | CDS_DIAS |
LG |
32LD650
|
TV turns on but with distorted sound, | Resolder all smd transistors and crystals on the main pci | tormes | |
LG |
42PJ350
42PJ350-SA |
When turned on, the relay arms and disarms | Ysus shorted. Short identified on the board's fets, possibly caused by dry thermal paste. | Replaced two 30f124 and two 30j124 that were shorted and applied new thermal paste to all components of this board. I also advise you to resolder the power supply board and zsus, as they were already quite bad. | Flavio |
LG |
42PQ60D
|
Tsound were times when it turned on normally, when it turned off, the screen didn't light up without sound | After changing several capacitors, I arrived at c139, put a 100uf50v one, the defect was resolved. | Marcelo Rodrigues | |
LG |
42LC2RR
42LC2RR |
Sometimes it turns on normally and then it doesn't turn on anymore | Both relays with burnt contacts | Replace the two relays | paulo cesar |
LG |
21FU6
CW81B |
The TV works normally, after a short time it turns on and off by itself. | Pin 24 of the lv76213 3c ci. It is short to change it. | Alexis | |
LG |
42LM3400
|
No image/with sound | Defect in the tcom capacitor, in the power supply line, opening the fuse. | Removing capacitor c213 from the board was already the solution, but it is recommended to put another one in its place | Sousatec Eletronica |
LG |
CM4350
0000 |
Don't read cd | Flat detached from the correct position | Just returns correct location and paste good luck! | Jhone eletronica |
LG |
49LB5800 47LB5800 55LB5800 50LB5800 60LB5800
|
Power supply does not arm, without 3.3v from stand by, it does not turn on. | Faulty oscillator not oscillating the primary. | Replace ci smd ic101 - 6a20 of 16 power supply legs | Samuel Silva |
LG |
32LB530B
|
Restarting - turns off randomly | In my opinion, it seemed to be the main pci it was the pci: t- with | I replaced the t-com and everything returned to normal. | PC - Anchieta ES |
LG |
MCT806
|
Normal sound comes out afterwards | Check if you have the 48v and check the 12v | If you have these two normal voltages, changing the thermal paste is resolved. | Protec Eletronica |