Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
EURO4 TX25LD4DP
|
Dead, comes on if external speakers are disconnected | R2702 150k o/c on c board (low +22v, +18v supplies on c board) | ||
| PANASONIC |
EURO3W TXW28R3DP
|
No sound from internal or external speakers, ok on headphones | No 12v on k board, dj on ic7502 12v regulator | ||
| PANASONIC |
EURO3W TXW28R3DP
|
Loptr q552 s/c | Replace q552 bu2508axrl and resolder line driver tx t502 | ||
| PANASONIC |
EURO3W TXW28R3DP
|
Int. goes to stby | Resolder line driver tx t502 | ||
| PANASONIC |
EURO2S TXXXAD1DP
|
Dark pic with int. sparkling from the crt base | Replace p362 preset brightness control on the crt base | ||
| PANASONIC |
EURO2S TX29AD2DP
|
Won't go to stby, sound mutes and odd row of dots float down screen | Replace relay rl6001 (tse10818) on front control pcb | ||
| PANASONIC |
EURO2S TX29AD2DP
|
No surround sound | Ic506 tda2030 | ||
| PANASONIC |
EURO2S TX29AD2DP
|
No sound from centre or rear speakers (only quiet hum) | The +19v line down to +10v, replace ic2505 tda2030av , also check ic2506/ic2517 | ||
| PANASONIC |
EURO2S TX29AD2DP
|
No audio, faint noise from all speakers in all modes (tuner and av) | Replace ic1301 msp3410-15tv (multisound processor) | ||
| PANASONIC |
EURO2S TX29AD2DP
|
Int. horizontal black lines from top to bottom of screen | D507/d508 ma723ta5 leaky | ||
| PANASONIC |
EURO2S TX29AD2DP
|
In autosearch won't store bbc1/bbc2 | Bbc changed channel no id, replace eeprom ic1871 with new software (27c010a09c) | ||
| PANASONIC |
EURO2S TX29AD2
|
Tripping, red led flashing, relay operating | Fault caused by sound power supply not running and pulling down scl3 data line. replace r2502, r2503 150k on k board | ||
| PANASONIC |
EURO2S TX29AD1DP
|
Excessive width with e/w error | Q593 bc547b | ||
| PANASONIC |
EURO2S TX25AD2DP
|
Won't go to stby | Q667 bc547b o/c | ||
| PANASONIC |
EURO2S TX25AD2DP
|
Trips to stby every 2-3 secs, frame collapse | I601 vdp3108appa1 | ||
| PANASONIC |
EURO2S TX25AD2DP
|
No sound, no pic, led pulsing dim-bright | Relay rl6101 (tse10818) faulty, replacement from goodmans 1430 works ok | ||
| PANASONIC |
EURO2S TX25AD2DP
|
Dead, no startup | 5v supply to ic1801low because ic1601 an78l05ta faulty (5v regulator) | ||
| PANASONIC |
EURO2S TX25AD1DP
|
E/w fault | Q593 bc847b s/c | ||
| PANASONIC |
EURO2S TX25AD1DP
|
Dead, tripping | Q651 o/c (part no. tfd312s0f632) | ||
| PANASONIC |
EURO2S TX25AD1DP
|
After replacing eeprom set comes on to channel 0 and 'normal' settings will not memorise | Press together 'status' on r/c and 'function' at front of tv. the set will run 'self-test'. switch the set off, then back on and re-tune |