Search: panasonic
Results: 2900
Make Model Symptom Problem Solution By
PANASONIC ALPHA 2
No picture because the brightness control voltage The decoupling capacitor c309 ( louf , 50v ) was leaky.
PANASONIC ALPHA 2
No picture No brightness control volts pin 20 tda3505 ic602; c309 10µ 50v leaky
PANASONIC ALPHA 2
No nicam sound or display for nicam/mono sound 6.55mhz osc not oscillating. c2549 0µ01 connected to pin 9 ic2502 faulty
PANASONIC ALPHA 2
No luminance Tda4565 cti chip on subpanel
PANASONIC ALPHA 2
No focus - looks like crt. O/c. blue choke. on crt base
PANASONIC ALPHA 2
No analogue bars or txt except in mix C3526 10nf ceramic cap leaky in txt contrast cct
PANASONIC ALPHA 2
Loss of sync, screen blank then shuts down with squeal after heated Check ic501 tda2579a with freezer - if it cures the fault then chip is sus
PANASONIC ALPHA 2
Loss of line hold int D/j around lopt ( t551 )
PANASONIC ALPHA 2
Lop transistor leaky , fusible feed res oc. Resolder line drive transformer pins
PANASONIC ALPHA 2
Line op transistor sc Resolder line driver tx
PANASONIC ALPHA 2
Line op tr sc r567 oc d854 sc Ic801 str54041m
PANASONIC ALPHA 2
Line down rh side of screen C858 1000µ 25v bad connection to pcb
PANASONIC ALPHA 2
Left hand sound chan. dist. C2442 ceramic ( c2441 for rh side )
PANASONIC ALPHA 2
Int whistles Dry joints on lopt overwinding
PANASONIC ALPHA 2
Int pic Check for dry joints connectorr b4 (at front of chassis under crt rim)
PANASONIC ALPHA 2
Int or weak colour Dl601 chroma delay line
PANASONIC ALPHA 2
Int non start R854 ( 0.47 ) change to 0.33 pt. no. erq1cktr33s
PANASONIC ALPHA 2
Int mains fuse f801 blowing Mains smoother cap c807 100µ 400v
PANASONIC ALPHA 2
Int loss line hold Lopt dry jointed
PANASONIC ALPHA 2
Int flashing with speckles & going off Check crt fixing bolts to aquadag