Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	29PT9467C/78 SK5.1L CA	Vertical closed in half, colored horizontal lines at the top of the screen.	Vertical and kinescope plate	Replace r924, r919, q904, q904, c904 e d452	danielpauly
PHILIPS	FWM996/78	No sound from outputs	R 910 of 39k, close to the power supply capacitors. the board of this amplifier and the fwm 592/593amp pcb		Vanoil
PHILIPS	20PT3331/78R	Closing the vertical top and bottom of the screen.	C2446 (changed)located next to th	Replace the same.	Jarbas (ELETRO-SERV)
PHILIPS	21PT5435	Vertical closed and turns off	R 3448 and 3445 open, also check if there is 8 VDC on the 7496 emitter, if not, it will not open vertically		EDGAR THIZ
PHILIPS	29PT9467C	TV turns on and off with dark corners activated protection note: with image on screen the TV turns on.	Capacitor c438 272 j ou 2k7 seco	Replace the memo and the TV is ok.	celso cafelandia pr
PHILIPS	AZ1134	No sound on CD and radio, exit ok	Function key sw1, and q5 and q8 (mute) with leakage	Cleaning sw1, and changing q5 and q8 or eliminating the 2 transistors	eletronicadoalemãThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT9467	Audio with superimposed whistle	Asp plate crystal (the one that stands upright)	Solve it / if it doesn't solve it, replace it	warley cesar
PHILIPS	PT222A	Blowing fuse	Transistor 7518 short, changed transistor and c 2518	Resolved	sergio
PHILIPS	21PT836\78 L9.01A	No Audio\no sound - note: all voltages in the normal amplifier tda 7057aq.	Pencil tip inside the female jack.		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT836\78 L9.01A	Note: all supply voltages in the normal amplifier (tda 7057aq).	Cause: pencil tip (graphite) inside the earphone's female jack (on the front panel) phew!!!!!		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21PT5433 L03.1L	Flattening of the image only at the bottom of the screen	100n capacitor 2488 connected to pin 26 of the ci 7200	Make the replacement and see for yourself! beauty?!	elsonkatin
PHILIPS	21PT5433	Contrast does not work	After testing everything and finding nothing	I disconnected pin 49 of the ci 7200 (processor). problem solved	This email address is being protected from spambots. You need JavaScript enabled to view it. (bruno)
PHILIPS	40PFL5605D	Doesn't work	Power supply turns on but 3v3 is missing from the micro	Shorted d907 d911 diodes	Alvaro (prolar)
PHILIPS	21PT5433	It turned on then turned off in approximately 2 minutes	C2463 and c2465	In my case, that's all it was. Thanks guys, let's send you a tip lol	Rafael Dores
PHILIPS	29GX1899	Turns off as soon as it comes out of stand-by	Check the voltage of the ic 7800 and resolder it and check the diode 6571 in4141	Replace the diode 6571 in4141	DAVI PEIXE-BOI
PHILIPS	42PFL3604	Doesn't turn on, everything is off	C806 4u7/450v exhausted in the primary causes the burning of other components in the primary of this 3v3 power supply.	C806 4u7/450v depleted, r801 2r7 and r825 2r7Ω open and u801 = fsq510 shorted	BRUSKE
PHILIPS	29PT554	Apparently normal power supply, but it doesn't turn on, triggers protection	C2551 47 x 160v seco.		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	20PT3331	Works for a few hours and appears retrace lines and turns off	Defective scrim potentiometer	Flyback replacement	eletronica reis
PHILIPS	20PT3331	Turns off after some time	Capacitor 2303 on the tube plate	Replace without measuring	eletronica reis
PHILIPS	20GL-14GL L1-RO3-GR1VA	No secondary power supplys.	R3319 of 100k open	Replace	jasvan souza