Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
20GL1346
GR1A |
It turned on, (but it didn't work) it had 70+ and 12 v, but on pin 10 of the tda, only 6 volts | Poor contact transistor 7205 | Re-welding, replacement of 7205 - bc 338 | |
| PHILIPS |
FWM663X
|
Device does not turn on | Secondary power supply rectifier diodes | Replace diodes | eletronicaapolo |
| PHILIPS |
29PT4640/78
L01.1L |
Turns on and then turns off. image flashing and changing colors. | As a guarantee, I replaced the c2455 (47uf/25v) and the transistors 7461 and 7463 (bc337 and bc327), but the TV only returned to normal operation after adjusting the screen. | Gilcimar Rocha Pereira | |
| PHILIPS |
29GX1899
|
Vertical | C 2657 r3653 tda8351 | R 3653 put 220r 3w - c2657 replace directly without measuring - tda8351 | ELETRONICA MAURI JUNIOR |
| PHILIPS |
21PT9467
|
Tv after 10/15 minutes, vertical starts to close | Deflector coil | Replace it - if you have good experience you can recover it | eletronicaapolo |
| PHILIPS |
21PT5433
|
Weak tube??? -no- everything indicated that it was the tube (very new TV), blurred RGB image, faded screen, wrong focus and then turning off! | Replace r3446(1r) with one of (0.47r) or smaller. | Alextecnico | |
| PHILIPS |
28PW6441
|
Excess screen. screen turns white with retrace lines. | 100r resistor 3351, driver board location. | Replace for a new one, TV is ok! #let's help, post your tip# | andlss (AL TECNOLOGIA) |
| PHILIPS |
28PW6441
|
Excess screen. screen turns white with retrace lines. | 100r resistor 3351, driver board location. | Replace for a new one, TV is ok! #let's help, post your tip# | |
| PHILIPS |
21PT9467S
|
Vertical folding top with 3 colored lines | R304 de 220r/or | Replace mentioned item | eletronicaapolo |
| PHILIPS |
29PT4641
|
Contrast does not work | 3451 open resistor | pardalzito | |
| PHILIPS |
40PFL3805D/78
|
TV doesn't turn on | D-210 d-510 q-501 r-517 u-501 f-101 | Replace them all | EDILSON AZEVEDO |
| PHILIPS |
21PT5456
|
Turns on with normal image. then turns off. | Change c 2444 of 470 x 16v in the filament line | edimilson de osasco | |
| PHILIPS |
14PT316A
L9.2A |
Turning off in 5 seconds if you hold the channel button + TV it stays on if you release it it turns off | Transistor 7620 bc547 button side channel | Replace | BETO2828 |
| PHILIPS |
29PT9467
|
Suffered an electrical discharge | Replace r-3532 ,ic 7531tea1620 | WARLEY CESAR | |
| PHILIPS |
21GX1666
|
Image all jagged and shaking | Replacement of 47uf 160v c2448,c2447 capacitors | julio.sertemaq | |
| PHILIPS |
HPS- 2185
|
Doesn't turn on anything, totally inoperative. | The stand bay LED does not light up and the secondary transformer has very low voltage | Swap c808. | lou |
| PHILIPS |
29PT4631
L01.1LAC 2K3 |
Does not tune uhf | This defect is caused by the eprom, just adjust it! | Enter service mode, in the option menu, if op 1 is set to 0, replace it to 128, exit service mode and tune again. | |
| PHILIPS |
29 PT
L03. IL |
Without video with lines, but with characters | R 3442 open on fback pin 10 | Tonin Coxim MS | |
| PHILIPS |
14GL1014
|
Black screen no image no drizzle | C2410 no pé do vertical 100uf 25v | Replacelo | antonio nobrega(patos pb) |
| PHILIPS |
FWM416
|
No sound | Amplifier on level under pin 13 of the stk433-870 | Replace q721/716 2n5551=mpsa42 e q722 bc556 | VITALTEC |