Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	37PFL5332	Turns on the image appears for 15 seconds and turns off	U-202 change without measuring		VIDEOTRON
PHILIPS	20PT324A L9.2	Very weak channel reception	Filter 1003 (m1967m)		joaomvjr
PHILIPS	21PT9467C SK-1LCA	Turns on with image and no sound, doesn't turn on, locks keyboard, turns on only with drizzle or white screen.	Zd604		saffier
PHILIPS	29PT5645	No image	Shorted picture tube	Replace tube	ELETRONICA MAURI JUNIOR
PHILIPS	20PFL5122	There is no image, the lamps do not light up	A faulty light bulb triggers the protection and no one lights up	You need to replace it with a good bulb to avoid triggering the protection, just leave it off	eletronicaaeb
PHILIPS	20GX1669	Does not turn on LED blinks 2 times	Ci vertical	Tda8351	ELETRONICA MAURI JUNIOR
PHILIPS	21PT1663 L7.2E	Doesn't start. LED blinks weakly and without voltage at the power supply output	C2550	Substituir c2550	jose almeida tavares
PHILIPS	25PT5321/11 GR2.4	When turned on, the image appears for 1 or 2 seconds, then the screen is dark with return lines and a light line at the top. If you change the screen a little, the video tends to appear very dark.	One of the kinescope's cathodes is nearly short-circuited. in my case it was blue (I tested the cathodes with a rejuvenator).	Use a kinescope rejuvenator to eliminate possible short circuits in the cathodes.	AleVict
PHILIPS	29PT4635/78	White lines across the screen as if it were normal high sound screem and it doesn't turn off.l	R3477 from 150r open.		hndrsn
PHILIPS	GR 1045... GR1L1I-VA- RO3	After changing the fly back, only the LED and the 35V power supply blink.	+12v protection activated	Raise d6904, if it works, put a 13v one	jasvan souza
PHILIPS	29PT4635	It turned on and then turned off, I changed it c2455 47u turned it on and held it but the screen is closed and serrated.	Check the deflector as it makes a strange noise.	Changing it is beautiful (dhf-2912pl) 1.8 to 2Ω horizontally and 13.6Ω vertically.	Eronaldo(arteron)
PHILIPS	29PT554/78R	The TV sometimes turns on and sometimes doesn't, when it doesn't turn on the LED blinks continuously and the b keeps pulsing.	The power supply does not activate, the slow starter does not work.	C2540=100μF 25v was replaced, it was average in the test at 80μF, and c2530 of 1μFx100v was also replaced, I replaced the c2530 with a 2.2 x 100v one, I replaced the value of the original and it worked beautifully.	Armando da Eletronica EvoluSom.
PHILIPS	14PT3336	Vertical closed	Varicap	Replace varicap	ELETRONICA MAURI JUNIOR
PHILIPS	29PT558 L01.1L	Hits the relay and doesn't turn on.	R3543 (82k)	Replace	joaomvjr
PHILIPS	29PT554A	Retrace and disconnect lines (without 180v)	R3340 pci tube 0bs: measure d6335 sometimes with leakage and the r3340 burns again!		Guto
PHILIPS	14GL1015	Low brightness, opaque image	R3555 (27k) open	Replace and run for the hug	Eletrônica Staub
PHILIPS	21PT5433	Doesn't start	Check resistor 3527 primary power supply		amsmariano
PHILIPS	14PT3131/78R	Retrace lines at the top of the image	68nf/250v dry capacitor position 2460	As I didn't have a 250 volt one in stock, I replaced it with a 50 volt one since the vertical one works with low voltage.	Helio Eletrosonic
PHILIPS	40PFL5605D/78	Total shutdown.	D707 and d711. I used the uf4004 because the 1n4004 is not a quick cut and here in Belém the material is complicated.	I appreciate the tips from friends. ferraz, bruske and electronicaaeb.	@gepe
PHILIPS	14PT4331	When you turn on the TV, the image is a little blurry and turns off. It looks like a tube defect.	R 3444 amended		Esper