Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
21PT5433
L03.1L |
Image appears with retrace lines, then image appears and then turns off. | Qah 463 (Basakh 46b). | Replace, it looks good but it's bad. | joaomvjr |
| PHILIPS |
14PT3131
|
Turn on close side turn off | Tea 1506t | Tea 1506t | alex |
| PHILIPS |
29PT4631/78R
|
Burning the bu4508dx in a short time of use | C-2455 47mf/35v | Replace and also as a precaution, replace transistors 7461 and 7463 | PATRICK |
| PHILIPS |
20PT3331/78R
|
Retrace lines at the top of the screen. | If replacing the electrolytic capacitors does not solve the problem, replace the polyester capacitor (plate reference 2460) which is located between resistors 3446 and 3444 at the foot of the fly back | Ita S de Sá | |
| PHILIPS |
14PT3131
|
Secondary power supply with low current with an 80v | So I went straight to the ic tea1506t power supply regulator | It was just a matter of changing and running for a hug. | DIEGO LIMA NOVA TIMBOTEUA PA |
| PHILIPS |
29PT554
L.9 |
It would turn on after 2 minutes, the relay would turn off after knocking, not even the primary power supply would turn on with time, it would turn on | Photo coupler | Photo coupler | fernado tj.. |
| PHILIPS |
HTS3090
|
Display off | Open resistor r986 of 4.7r | orlando lott | |
| PHILIPS |
29PT4631/77
L01.01A |
Turns on with vertical line in the middle of the reduced square...after 5 seconds it turns off | Vertical outlet in poor condition | Replace fusitor (3488) of 4.7Ω for one of 5.6Ω, also damper (6487) rgp15d, tda 8359j, all electrolytic capacitors included c2444, c2441 of 1μF/50v, also ceramic (2471) of 100n and (2473) of 100n ....replace everything without testing | barnes |
| PHILIPS |
29PT4635
|
Thin vertical stripe with drizzle | D6467 leaking | Replace without testing | antonio nobrega(patos pb) |
| PHILIPS |
21PT5433/78R
|
Image closed 5cm above, with retrace. | C2460, c2465 e r3444 | If after changing them, the sound disappears, replace c2444. | ÁdrianChapadãodoCéu |
| PHILIPS |
29PT9467
|
Burning horizontal outlet | Flyback with escape | ||
| PHILIPS |
21PT9467C/78
|
Closed vertical, line at the bottom | Right away I saw the ci tda4865aj stuffed, as I had the tda4863aj in stock, I replaced it and it worked | Ci replace | Eliel |
| PHILIPS |
14PT110A/78R
L7L |
Vertical closed, missing pulse voltage on pin 8 of tda 3653b | R 3406, 2k2 open resistor | Replace it and the TV is back to normal | Alfredo Jose Resende Neto |
| PHILIPS |
21PT5435
|
After being on for a while, it turns off. | If you've already done everything and changed what everyone said and it didn't work, disconnect pin 36 on the micro ehto and send the TV away. | CALIXSERVICE | |
| PHILIPS |
14GL1311
|
Low power supply, and it doesn't turn on. | Replace ts355 ,bc558. | ||
| PHILIPS |
20GX1659
|
Kind of out of tune | Change coil 5210 | ||
| PHILIPS |
14PT314A/78R
|
It goes into protection in seconds, you have to insist to see the glow with a vertical stripe. | Micho latch on the trail with the vertical exit | Just scrape and solder the ci pins | alecio dal pozzo |
| PHILIPS |
21PT6437
|
Dark screen, more with sound and characters. | R 3442 de 100k | ||
| PHILIPS |
21PT9467C78
|
Closed vertical. the deflection line at the top of the screen | Lack of negative voltage at the vertical output | Replace the resistor that feeds the negative voltage that comes from the fly back | |
| PHILIPS |
20PT3331
|
TV inoperative with primary power supply ticking.....ticking....ticking...., but when using the heat steam station on the plate it worked, but when turning off the TV and it cooled down, it no longer turned on, So that's when I started looking for the defect in parts, it was when I threw heat on the photo-coupler and the TV turned on... | It was the photo coupler, because it had to be replaced and the TV worked normally |