Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
29PT658
|
No uhf signal | Service mode | Enter service mode and if op1 is 0, set it to 128 | |
PHILIPS |
29PT658A
|
Poor width and no adjustment eww in the service menu | Adjust in service mode. | Service mode, "options" op 3 and replace to 128 or 164. exit service mode, turn off the TV, turn it on again, enter service mode again and see in the horizontal "geometry" part if the eww option appears, this adjusts the width | Edson Caeté |
PHILIPS |
14PT4131/78
|
Low sound when it increases I heard it very softly | Capacitor 2444 470/16v replaced, the sound was excellent | MARCIO FF | |
PHILIPS |
29PT4641/78
L04U |
When turning on the TV, 3 lines in red, green and blue appear at the bottom 5cm above the end of the screen and then turn off | D6457 smd em curto | Replace the same | Assolini |
PHILIPS |
FWD798/55
|
No audio from surround speakers and center speaker | Interconnection cable between the main device and the sub-woofer box with broken leads | Redo the cable or replace it. | Jheliocavalcanti |
PHILIPS |
CED228X/78
|
No voltage (12vdc) at the electrical antenna output | Resistor r113(2,2r x 1/8w) aberto | Replace the same. | Jheliocavalcanti |
PHILIPS |
FWD798/55
|
No audio on sr channel | Capac.elet. c422(4.7mf x 16v) on the main board is open. | Replace it yourself | jheliocavalcanti |
PHILIPS |
FWM 143/55
|
Inert cd mechanics | Ci/ la6548 defective | Replace of the ci/la6548 that controls all the mechanics of the same | |
PHILIPS |
42PFL3604
|
Power supply sometimes breaks sometimes not | C 806 4.7mf 450v semi seco | julio itaguai | |
PROVIEW (PHILIPS) |
TL-29N6P
|
Cushion effect | TV has a pillow effect image | Replace 6.8μF x 50v capacitor c446 (it is located between 2 heatsinks | Gilnei |
PHILIPS |
40PFL5615D
|
Does not turn on, primary power supply with no apparent damage. | Check for short in the rectifiers of the +b 3.3v line | BRUSKE | |
PHILIPS |
14GL1015 14GL1316 20GL1045 20GL1045 20GL1047 20GL1346
GR1-VA |
No image | Capacitor 2410 open | This open capacitor creates excess lines at the top of the screen and the television cuts the signal so as not to damage the tube | Bruno Capozzoli |
PHILIPS |
20PT3331
|
Closing vertically at the top of the screen | Cap 2465 10uf 160v | preá | |
PHILIPS |
21PT6456/78
|
Turns off after turning on. the horizontal output is heated. | Fly-back (jf0501-19272) shorted | Replace for a new one, TV is ok! #let's help, post your tip# | andlss (AL TECNOLOGIA) |
PHILIPS |
21PT9467C/78
|
Vertical almost completely closed, with intertwined lines in the middle. | C315 and c316 of 1000 uf for 25 volts, swollen and low capacity. | They were replaced and it was ok. | Armando de Olimpia, Eletronica EvoluSom. |
PHILIPS |
29PT9467C
|
Turns on but no image | C504 (screen capacitor) - change without measuring | ||
PHILIPS |
42PFL3403/78
|
Doesn't work | D130, 131,234 and q201 (all shorted) | Replace of d130,131,234 and q201. | LUÍS PIMENTA |
PHILIPS |
21PT9467C/78
|
Vertical closed at the bottom | R310 (0.68x2w) auterado | LUÍS PIMENTA | |
PHILIPS |
FWM-M371
|
Doesn't start. standby LED is on and nothing happens. | After checking all voltages and they were normal, the computer did not release the power on voltage. like everything else in order, the computer could only be frozen, after doing all the tests before going to change it, I checked the keyboard, which had the aux key shorted, I changed it and it started working, However, the CD would not open the drawer, after the necessary checks the drawer motor would not start and would not initialize the system, after changing everything returned to normal. | CALIXSERVICE | |
PHILIPS |
32PFL3403
LC8.1L LA |
TV blinks, turns off and turns on quickly | In addition to removing c303, c304, exchanging r 3k3 for 4k7, removing c922, also exchanging c 903 and c911 of 47x63 105° | joaomvjr |