Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
PT3336
|
I'm here | E-pron | juvenal-picos-pi | |
PHILIPS |
DVP3142KM/78
DVD |
He left | Change resistor r76 dvd returned normal | ||
PHILIPS |
21PT6437
|
Fully closed vertical | Ra 445 | Replace r3445 of 1r 1/2w tv came back normal | |
PHILIPS |
20PT228A
|
TV without video and sound | D 6405 | Replace diode d6405 | |
PHILIPS |
20PT326A/78
|
Turns on, standsby but there is no image, when changing channels the LED flashes but there is no brightness on the screen. | Adjust the flyback screen, if it is off the screen does not light up | Eronaldo | |
PHILIPS |
20GL1346
GR1-VA |
When turning on no image, no sound. with filament. when increasing the screen it only gave a return trace | C2410 100/25v with low capacitance close to the vertical ci | After replacing it, the TV was ok | Jose Gusmão |
PHILIPS |
20PT3331
|
When turning on, 3 lines appear at the top with the image closed a little and then it turns off | Capacitor poliester c2460 de 68k/250v | José Gusmão | |
PHILIPS |
20PT3336
|
It would turn on, after a few seconds it would turn off, the channel number would be streaked | I changed the photo coupler, it was ok. | wilhelm | |
PHILIPS |
VR 788
|
When inserting the VHS tape, it pulls and turns off. | The head cylinder does not rotate. | Oxidation on the board, measure and make a jumper. | azaujotec |
PHILIPS |
29PT4631/78R
|
When turning on the TV, the image appears with aliasing and a slightly reduced horizontal, then it turns off and when turned on again, the TV works normally. | Capacitor c2455 47mf25v with low capacitance. | Replace for another one, but you can put a 47mf 50v one | ROBERTO |
PHILIPS |
TP4635
|
Turns on, turns off and on the screen it appears when the horizontal trident is broken but it doesn't have it | I just had to change the electrolytic capacitor 2455 47x50 eos transistor 7461bc337 and 7463bc227 and run to hell | atonio | |
PHILIPS |
21PT534
|
When turning on the LED flashes once and returns to standby | 3470 open resistor | eletronet | |
PHILIPS |
29PT4641
|
Turning off when changing channels | As incredible as it may seem, it's a cold solder on the secondary ground "pin 12 of the flyback" | novaeletronicauberlandia | |
PHILIPS |
20PT3331
L03.1L AA |
Changing audio amplifier | The power supply works and the voltage drops and the TV doesn't turn on. | Changing audio amplifier | johnny busnadiego |
PHILIPS |
29PT9467
|
Buzzing in sound | As a testimonial | C879 replacement | DIGITAL TEC |
PHILIPS |
20PT122A/78R
|
Black band on the left side of the screen about 5cm wide pushing the image horizontally | D6464 - diode in4148 shorted. | The same was replaced | Hunter_40 |
PHILIPS |
42PFL5332/78
|
Dark image in the center of the screen and noise in the inverters | U202 photo aclopador na pci power supply | Replacement | paulo maceio/al |
PHILIPS |
14 PT1352/00
L.6 |
LED would light up but not start | C2515 47uf 200v with little capacity. 96v lows about 35v | sedeug | |
PHILIPS |
20PT3331
|
TV with no picture, no sound with just a white screen | Ci does everything | Replace ci and get fillet | afonso taquari eletronica |
PHILIPS |
20PT120A
|
Vertical lines. when you reduce the brightness the lines disappear | Check capacitors near the microprocessor probable cause of the defect cap.2364 | Cap. 2634 | ELETRONICA ROBSON(DEBIQUE) |