Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem
PHILIPS	GR1 AX	Dead	Check l5524 - 9v supply to line osc from pin 26 started from pulse on pin 11 of i.c. 7020
PHILIPS	GR1 AX	Blank screen , no sound	C2044 4mfd sc.
PHILIPS	GR1	Won't store analogue settings	St24c02cp eeprom
PHILIPS	GR1	Tuning drift on selected chans	Ht preset int
PHILIPS	GR1	Off with low growling noise	95v ok; no 9v start up - check c2523 6µ8 & l5524 1µ5
PHILIPS	GR1	Off - possible failure of lop tr & lopt	C2523 6µ8 50v
PHILIPS	GR1	Off	No ht or 9v ; 5v ok - lopt
PHILIPS	GR1	Off	L5524 1.5mh choke - can be int
PHILIPS	GR1	Off	95v & 9v present lopt faulty
PHILIPS	GR1	No pic - sound & eht ok	No a1s - lopt
PHILIPS	GR1	Dead - front led flashing	Lop tr o/c, ht now ok but no line - c2523 6µ8? 50v o/c and smoothing choke
PHILIPS	GFL2.30E 32PW9631	Poor pic (as if out of focus)	Svm coil not in operation due to wrong option codes. check the label on tube and re-enter for your version, eg,05,10,15
PHILIPS	GFL2.20E GFL2.3E	Dead	Loptr s/c, fet 7480 irf620 faulty - caused by c2423 390nf 215v short circuit.
PHILIPS	GFL2.20E 29PT828C	Stuck in stby	Resolder both ends of scan coils leads and resolder loptx
PHILIPS	GFL2.20E 29PT828C	Sound int. goes low and distorted, rear speakers crackling	Resolder earth links on component side of dolby module
PHILIPS	GFL2.20E 29PT828C	Set trips from green led to red, then back green to red	Ic 7540/7550 tda2616q on audio pcb
PHILIPS	GFL2.20E 29PT828C	Quiet buzz from centre speaker when playing back vcr via scart	Unclip the features board mounted behind the loptx on a plastic frame, turn through 180 degs and clip back into its frame (it works)
PHILIPS	GFL2.20E 29PT828C	No sound from front speakers in dolby or surround modes	Go to install menu, then tv config menu and set "external amp" to off
PHILIPS	GFL2.20E 29PT828C	Dead, led flashing	Frame ic tda8177 and c2260 100uf 63v
PHILIPS	GFL2.20E 29PT828C	Dead, green led flashing	R3148 120k gone high (large signal panel)