Search: philips
Results: 14233
Make Model Symptom Problem Solution By
PHILIPS G11
Dead - blowing mains fuse for no reason. Check fuse holder for being loose or charred.
PHILIPS G11
Dead - blowing 3.15a fuse intermittently. 470uf reservoir capacitor , bu208 , r1308 across l1305.
PHILIPS G11
Dark picture - brightness control inoperative D4090 ( bzx79-c4v7 ) s/c.
PHILIPS G11
Contrast - experience. Djs around contrast control.
PHILIPS G11
Channels - stuck on channel 1. Poor contact at pin 2 of plug 40.
PHILIPS G11
Brightness - low. Beam limiter transistor in psu leaky + mod jan 86.
PHILIPS G11
Brightness - decreasing - loss of colour lock C3150 ( 150u f ) , c5067 ( 10u f ) , 12v reg chip ic5073 ( tda1412 )
PHILIPS G11
Blowing - da4600. Intermittent connections on holder , c4079.
PHILIPS G11
Blank raster & no sound. Tr6462 ( bf196 ) .
PHILIPS G11
Black vertical bar in centre of picture. Check for solder bridge under chip capacitor c2460
PHILIPS FL4.27
Wrong synchronization, unstable colors D6417 on the lsp dependent on temperature, check/replace (4822 130 81223)
PHILIPS FL4.27
Wrong service batch of st24c08cb1 memory ic's Wrong service batch of st24c08cb1 memory ic's 4822 209 32283 ------ temporarily a wrong batch of earom's has been delivered, causing the fault "nvm memory not write protected" after replacing the earom
PHILIPS FL4.27
White picture and shuts of. No +200v on pin 6 ic7706 on picture tube panel. resistance from pin 6 tda611/q to mass too low ( 15Ω.)
PHILIPS FL4.27
Unstable picture, horizontal jitter. Check/replace r3405 on the lsp. (4822 051 10303 for 50 hz sets; 4822 051 10333 for 100 hz sets).
PHILIPS FL4.27
Tuning does not function Resistor r3240 on lsp in v-tuning wire broken.
PHILIPS FL4.27
Total inoperative, leds blinking, error 99 Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2,
PHILIPS FL4.27
Ticking noise and line in picture Transistor 7381 (bc848c; 5322 130 42136) defective when hot.
PHILIPS FL4.27
Synchronization, picture disappears D6703 and t7704 defective on picture tube panel.
PHILIPS FL4.27
Supply switch-off sometimes Check the +5 stand-by. this voltage has to be 5.5v and may not vary. when the voltage drops below 5.2v the set switches-off. cure: check leakage of d6266 (bzx79/f6v8; 4822 130 34278)
PHILIPS FL4.27
Supply +5v too low, black horizontal bar in picture. bad sync. Check/replace ic7551 (lm358n; 4822 209 70672)