Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
FL1.9/1.1AD
|
No nicam sound with error code - power on - st/by & language-1 | Indicates fault in nicam dec - x1602 10mhz xtal faulty | ||
| PHILIPS |
FL1.9
|
Leds flash + no nicam | Try x1602 10mhz xtal | ||
| PHILIPS |
FL1.7AA
|
Sync missing | Sync signal missing at pin 5 ic7400 tho ok at pin 6 ribbon cable h/s20. crack in print at edge of board & check adj of r3228 in the high end box | ||
| PHILIPS |
FL1.7AA
|
Int blanks out | Dry joint jumper 4404 by plug l03 | ||
| PHILIPS |
FL1.7AA
|
Dead - flashing leds error code 99 | C2504 102k (10nf ?) 2kv changed for 3kv type | ||
| PHILIPS |
FL1.7
|
Wrong synchronization, unstable colors | D6417 on the lsp dependent on temperature, check/replace (4822 130 81223) | ||
| PHILIPS |
FL1.7
|
Violet back color | Change the values of r3163 (470Ω) and r3165 (470Ω) to 1kΩ in high end box. | ||
| PHILIPS |
FL1.7
|
Unstable picture, horizontal jitter. | Check/replace r3405 on the lsp. (4822 051 10303 for 50 hz sets; 4822 051 10333 for 100 hz sets). | ||
| PHILIPS |
FL1.7
|
Tuning does not function | Resistor r3240 on lsp in v-tuning wire broken. | ||
| PHILIPS |
FL1.7
|
Totally inoperative. | Transistors 7250 (bux85f; 4822 130 62509) and 7251 (bc848; 4822 130 61207) in microsops defective. or d6251 (llz-c5v6; 4822 130 80954) and r1250 (=r3230; 1Ω; 4822 052 10108) defective. or t7270 (bd825; 4822 130 41746) or t7201 (bc857c; 5322 130 427 | ||
| PHILIPS |
FL1.7
|
Total inoperative, leds blinking, error 99 | Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2, | ||
| PHILIPS |
FL1.7
|
Ticking noise and line in picture | Transistor 7381 (bc848c; 5322 130 42136) defective when hot. | ||
| PHILIPS |
FL1.7
|
The +141 is about 110v instead of 141v | It is recommended to replace the sops pwb (4822 310 31993). | ||
| PHILIPS |
FL1.7
|
Synchronization, picture disappears | D6703 and t7704 defective on picture tube panel. | ||
| PHILIPS |
FL1.7
|
Synchronization fault, "temperature drift" | Change the value of r3132 (1k5) to 1k2 in high end box. | ||
| PHILIPS |
FL1.7
|
Spook in picture | Use special antenna cables. codenumbers: 4822 321 61224 pal 1 meter 4822 321 61225 pal 2 meter 4822 321 61226 secam 1 meter 4822 321 61227 secam 2 meter | ||
| PHILIPS |
FL1.7
|
Spook (interference and noise) in 100hz sets | 1. use special antenna cables: 4822 321 61224 pal 1m 4822 321 61225 pal 2m 4822 321 61226 secam 1m 4822 321 61227 secam 2m 2. add 2 capacitors o | ||
| PHILIPS |
FL1.7
|
Sometimes in protection, or hor. width varies | Check or resolder on lsp the pins of e/w bridge coil 5521. | ||
| PHILIPS |
FL1.7
|
Shaking picture | C2101 in high end-box defective (4822 122 32999). | ||
| PHILIPS |
FL1.7
|
Severe moire patterning | Most modern colour televisions use automatic gray scale tracking and while the setting of the g1 may not seem to have a major effect on the picture brightness on a modern set, incorrect adjustment can have the effect of causing severe moire patterning if |