Philips Repair Tips

Search: philips
Results: 14245

Make	Model	Symptom	Problem
PHILIPS	34PT4873	Mono-carrier pcb-layout of l9.1a	For the above mentioned 21" sets the mono-carrier pcb-layout of l9.1a is introduced to increase the audio power and the way the sdm and the sam is entered is changed. they also have a new side av & headphone panel (e1). the 21pt3952 and 21pt3962 are t
PHILIPS	34PT4822	Mono-carrier pcb-layout of l9.1a	For the above mentioned 21" sets the mono-carrier pcb-layout of l9.1a is introduced to increase the audio power and the way the sdm and the sam is entered is changed. they also have a new side av & headphone panel (e1). the 21pt3952 and 21pt3962 are t
PHILIPS	32W6332/05	No sound	Tda2616 audio o/p ic & wickman fuse o/c
PHILIPS	32PW9765	Pumping effect (horizontaly) of the picture	Pumping effect (horizontaly) of the picture during picture changes from low to high luminance implement a high voltage bleeder in the set on the following way: modifications on the large signal panel: change position c2448 into 10nf (4822 121 41857)
PHILIPS	32PW9763/05 MD2.25E	St/by only with led flashing	Main micro on control board pin 53 stuck hi due to d6227 zener 3v3 sm o/c. for more info see tv mag nov 2001
PHILIPS	32PW9611/58	Green led comes on at sw on briefly then reverts to red led (st/by) with no 140v at +a	Full wave bridge rects all s/c & safety res 2r7 15w. the chopper mosfet, with strange markings was also s/c type :g239-1hex fitted a irf pc 50 rated at 11amp. in lieu
PHILIPS	32PW9544/05M	Dead with flashing led	St/by relay - can swap this one with degauss one for test purposes pt no 4822 280 10375
PHILIPS	32PW9525	Pumping effect (horizontaly) of the picture	Pumping effect (horizontaly) of the picture during picture changes from low to high luminance implement a high voltage bleeder in the set on the following way: modifications on the large signal panel: change position c2448 into 10nf (4822 121 41857)
PHILIPS	32PW6515/05 SA10E	Hum from front speaker	Remove link 9710 & connect link from 9710 (c2702 end) to link 9278
PHILIPS	32PW6332	Service mode adjustments	Short pins s42 & s43 on signals board (upright board on l). now have various options available
PHILIPS	32PW6332	No sound	Enter service mode & check option ni (nicam) - should be "y" (yes) next to it
PHILIPS	32PW6005/05 SA10E	St/by only	Resolder smd tda8885, it is located on the sub-board next to the tuner.(runs very hot)
PHILIPS	32PW6005	Set inoperative and ptc defective.	Check and replace if necessary position 3912 on the large signal panel by 4822 116 10105 iris code : m11x
PHILIPS	320 MONO	No picture.	Bad 07, Takad.
PHILIPS	31DV3	Not recording sound	The cause of this fault was traced to 3230, the resistor had gone high. the resistor had changed from 2k7 to 4k3.
PHILIPS	31DV3	Intermittent loss of picture and sound, teletext also affected	Check eprom on the teletext pcb. check ic 7751 (kstx1), might be faulty when warm.
PHILIPS	31DV3	Change of threaded in time after rewind	After rewind to tape begin, the above vcrs go to the threaded in position. if no function is requested, after 6 minutes the vcr dethreads to the stop position where it stays for 2 minutes before returning to standby. from week 41 the waiting time at th
PHILIPS	2B 28CT8890/79R	White screen with normal sound	C2638 4µ7 350v in rgb o/p supply
PHILIPS	2B	Unacceptable long heating time of older picture tubes.	Add a diode 1n4148 (4822 130 30621) in serial with diode 6492. this will not effect the lifetime of the picture tube or the set. it prevents that the video controller mutes the picture untill the 3 guns are within the same range of emission.
PHILIPS	2B	Top half of picture missing	As the set warmed up the blank area would slowly shrink until it disappeared completely. the sandcastle pulse was checked at pin 10 of the tda4580 and the pulse width of the frame blanking pulse was found