Samsung Repair Tips
Search: samsung
Results: 3843
Results: 3843
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG |
UN40D5000
BN44-00458A |
Blinking LED does not turn on | LED bars burned out and q9101 shorted, zeroing 114v supply | REPLACE COMPONENTS | NILTEC |
SAMSUNG |
LN32B350F1
|
It turns on, has sound, rear light and video, after a while the rear light turns off and continues with sound. | Defect in the inverter circuit. which is together with the power supply board | Place a 2k2 resistor between pin 14e16 of the ui801 smd ci (without 2006). 14-vcc-supply voltage pin 16-en-enable pin. | Ademir tc |
SAMSUNG |
UN49MU6100G
|
It would turn on and within a few minutes the backlight would turn off with a dark image. | Thinking it was the bus, I opened the TV and tsound was an LED open. I replaced it for new ones, and when I called it, it had the same defect. So I went to see the power supply, it was ok. | I replaced the mains and it didn't turn off. it was perfect. | JC Eletrônica Cícero |
SAMSUNG |
MX-JS9000
|
Increasing volume goes into protection. "fan 2" appears on the display | Transistor fa07 open close to fan 2 connector | Replace it with another digital transistor if you don't find the same one | Stiltec |
SAMSUNG |
T27B350LB
|
TV doesn't turn on, just blinks on standby. voltage ( ps_on ) missing. | Check q202 is r206 on main board. in my case it was r202. replace with a 10k one | Júlio/ Eletrônica JM | |
SAMSUNG |
UN40EH6030
|
Stuck in standby | Transistor qq852 is broken, it is an n-channel MOSFET | Remove the wire from the connector corresponding to the p-on, the TV will turn on normally, then just replace the transisot qq852 on the power supply next to the connector, it is smd and is connected to the photo coupler | Ariel Santos |
SAMSUNG |
UN55F6400
|
LEDs on the bottom do not turn on | C9015 short open resistor r9015 | CLEBER LIMA RS | |
SAMSUNG |
PL43F4000AG
|
No image | TV came from another service, they had already replaced c5078, q5000, d5057, and q5014 but tsound was no image, checking the circuit I found an omic value of 30r between the base terminal and emitter, changing the ci u5022 returned the value of 10k and the TV gave an image. | IRIS TECCENTER | |
SAMSUNG |
LN19A330J1
|
White screen with no image | Fuse f1 on the vcom board | Replace and run for the hug | RYK |
SAMSUNG |
UN40D6900
|
When turned on, smart appears and restarts | Loose or open led | Cabeça | |
SAMSUNG |
PL43F4000AG
|
Blurry image, without definition. | Blurred image, at first I thought it was a defect in the ymain, but after changing it, this was not confirmed. Checking the zmain, I checked the 3r resistor r4063 (when I measured the voltage on it, it was around 5v, normal 15v) open, done the Change the image back to normal. | TECCENTER | |
SAMSUNG |
UN32EH5300G
|
Doesn't start | Power supply | Capacitor cm852(47μFx200v), diodos dm852 e dm851 (nur460) | Brackmann |
SAMSUNG |
PL43E400
|
Does not turn on, voltage vs/va rises and falls slowly. | The TV was defective in the rjp63k2, cap. polyester 330kv and no fgd4536, smd. I changed everything, re-welded the y, z and power supply, but it still wouldn't work. | After racking my brain for a day, I'm going to give the tip that Pablo Plasma from Mexico gave in a video, about an SF10A400H SMD diode, if on the diode scale it's measuring below .460, replace it because it's leaking. | World TV - Sorocaba |
SAMSUNG |
PL43F4900
|
Stop without stand by, normal power supply | On the main board close to the ic806 1g1m power supply connector, tsound was a short in the nearby capacitors. | Arimateia | |
SAMSUNG |
PL51E490
|
Does not turn on standbay off | Defect on main board ic1201 and next ic noclature 1g1s smd short | Marco.32 | |
SAMSUNG |
LN40B530
|
No image, lights go out | Ground pin 2 of sem2006 with 4k7 | ELETRONICA TENSAO R JACUIPE BA | |
SAMSUNG |
PL64E8000GGXZD
|
TV doesn't turn on. vs and va turns on and off when plugged in | Blue capacitor c5069 value 106 shorted on plate y. capacitor is close to the transformer. | rafaelmoraes99 | |
SAMSUNG |
UN55NU7100G
|
Does not turn on and does not respond to stand-by | Smd capacitor in the main pci position c219 | Airton Filgueira | |
SAMSUNG |
HT-Z320T/XAZ
|
Defective digital board | Turns on, but only opens the dvd drive. does not perform other functions. | ANISIO | |
SAMSUNG |
LN40C530F1M
BN44-00340A |
Dead power supply | Open 3.5a fuse fm801s causes 22nf/1kv capacitor c1831 shorted, after replacement tv turned on but without black light solution was to replace ub801 a ci 431 smd and photo pc803 | Maxwell |