Samsung Repair Tips

Search: samsung
Results: 3845

Make	Model	Symptom	Problem	Solution	By
SAMSUNG	CL29Z43MQ	Dark screen.	Measuring the screen I found 140 volts	I replaced the 508 capacitor in the tube socket, the voltage returned to normal. and we jumped for joy!!!	Eletronica Casa Dos Monitores Itumbiara ltda
SAMSUNG	CN5039CV	Turns on, turns off by itself	Short vertical	Replace ci do vertical	This email address is being protected from spambots. You need JavaScript enabled to view it.
SAMSUNG	21K40	This TV arrived sound with a strange chirping noise as if it were on the flaybak, I tested the capacitors around the flaybak and everything was ok, then I noticed some sparks in the deflector, which killed the defect.	This deflector doesn't sell new, so I put a CCE deflector but it doesn't open all the way and tsound's a finger missing from the top and bottom.	Then open the service mode [ when the TV is on standby press the control; mute,182,power that will turn on in service mode and just regulate and exit for hug	eletronica rosa de saron aracaju - se / Daniel levita
SAMSUNG	29Z30MQ	TV only worked in black and white	Solution and do a factory reset on it	With the ATV in standby, press the mute button on the remote control and then type 182 and press power, it goes into service mode, after that, just reset the TV and it's back to normal.	This email address is being protected from spambots. You need JavaScript enabled to view it.
SAMSUNG	CL29K40MQ	Luminous point in the center of the tube when switching off	D504 diode connected to g1 of the leaking tube	Diode code tvr10g	JOSÉ GUSMÃO
SAMSUNG	CL29K40MQ	Image disappears and appears at intervals of approximately 3.5 seconds	C 410 470mf/35v	Even though the capacitance was good on the capacitance, after the replace it was good (adjust sreen)	JOSÉ GUSMÃO
SAMSUNG	CL21C650ML	Excess width	Q 404 (fet 5n20 shorted)		HP ELETRONICA
SAMSUNG	CN3352Z	TV only had standby when turned on, it turned on but tsound was no voltage on the t401 transformer	When I checked, measuring the T40, the secondary was open, I just had to change it, the TV was ready, I hope someone needs this information of mine		cunha753
SAMSUNG	CL-29K40MQ K16A	Turns on and with sound and image does not appear	Weak tube	Put 12v on the filament for 5 minutes, no more, and the defect will disappear for a few months	joaomvjr
SAMSUNG	CL21A551ML	Turns on, but no image, no characters, no sound	C822, c821 e ic501	Capacitors c822 and c821 were found to be swollen, after replacing it did not solve the problem. the defect was remedied after replacing the ic501 tda6107	eletroademar
SAMSUNG	LN26A450C1	Screen completely white/does not turn off via remote control	Power supply electronic cap cm859/858/853/851/852/cb852	Tsound is no point in testing, they have to be touched	jheliocavalcanti
SAMSUNG	CN-5083VB	Normal voltages power circuit working, tsound was 8v on p 36 of ic 101 but it didn't trip.	Q 401 base without r404 power supply.		carlinhos100
SAMSUNG	RT21MHSW1/XEP SD/62Q-L1U2TS	Broken shelves	Buy 2 shelves		candido marcelino
SAMSUNG	740N-C LS17	F 301 burns	Cause	Sol	eletro
SAMSUNG	740N C LS17	F 301 burns	Cause	Sol	elson
SAMSUNG	740N C LS17	F 301 burns	Cause	Sol	elson
SAMSUNG	CN 3355Z	Tube without image.	Filament does not light/normal sound.		Edson
SAMSUNG	CL21Z50MQ	No image in av1 or av 2 but tsound is sound	Menu, configuration, music mode, leave off		BRUSKE
SAMSUNG	CL29K40MQ	Image appears and disappears constantly	C410 w/ low capacitance	Replace and adjust screen and focus	ÁdrianChapadãodoCéu-Goias
SAMSUNG	LN32A330	Saturated or negative image	Ci smd as15g	Just replace the ci as15g on the tcon board, to confirm, place your finger on top of the ci with the TV on if it gets too hot, just replace it.	alexxx