☰

Samsung Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: samsung
Results: 3800
Make Model Symptom Problem Solution By
SAMSUNG LN40B530P2M
Just stays on standby 5v dead voltage. Shorted smd capacitor c2508 near the usb input. evando viana
SAMSUNG LN40B530P2M
Just stays on standby 5v dead voltage. evando viana
SAMSUNG UN48JU6000G
Voltages do not stabilize Brief resoldering of power supply board Eletroart
SAMSUNG UN32D5500/UN40D5500/UN46D5500
Av/component does not work Connector Tighten the connector well, tsound is a space, placing it carefully, not producing video/sound. Tsound is a bit of play if you press it hard enough. resolved
SAMSUNG PL60F5000
Turning off Z sus board q4000 q4002 fgd4536 short Replaced it was fine = good luck! JHONE ELETRONICA
SAMSUNG LT22A550 BA44-00448B
Turns on normally when unplugged, LED STB no longer turns on Qm852 14184 Put a smd aod4184a in one place, put a wire on the drain pin for the plate, untwisted the g and the s ELETRONICA ELEKATROM
SAMSUNG UN58H5200AG
Reduce led power supplys Avoid burning out the LEDs Replace resistor r-9161 p/ 2r2 eletronica fama
SAMSUNG PL51E450
When turned on, it goes into protection and returns to stand by Y sus in short I replaced the fgpf4536 which were shorted but the image was blurry and drizzled, I didn't replace the smk630 as they were not shorted, but when I took them off the board and measured, they were leaking a lot, I just had to replace the 2 smk630s and run to the hug. mfelipe
SAMSUNG UN48H6800AGXZD
Turns on without image - backlight does not come on Series defect, on the display, shorted capacitor. fuse f3 open on tcon board. Kabo Informática
SAMSUNG UN40EH6030G
Stuck in standby Broken transistor qq852 Remove the wire from the connector corresponding to the p-on, the TV will turn on normally, then just replace the transisot qq852 on the power supply near the connector Ariel Santos
SAMSUNG LN32C350D1M
Stays on stand by and does not turn on Ic 102 processor - board replacement The 13v voltage kept dropping and coming back on, I heated the processor with a hairdryer and the TV started working again... I did the reballing but it didn't solve it. I replaced the main board and the TV worked perfectly again. TV e Cia
SAMSUNG UN32C5000Q
No sound from sub woofer speaker Capacitor smd 1kpf no pino 32 do ic1402(tas5715) See voltage on the speaker pins if it is not around 6v, it must be this capacitor NELSINHOPIRA
SAMSUNG CL29A551GQ
It doesn't turn on, I press the on button and the LED doesn't go off Change all the keys, escape them Dj pituka
SAMSUNG UA55D70000L
TV turns off intermittently Check the resistors connected to the cnl802a and cnl802b led bar connectors Andreas
SAMSUNG 29K40
Turns on and off Resistor 169 39k auterated JR Alagoinhas BA tec
SAMSUNG CL29A551GQ
It doesn't turn on, I press the on button and the LED doesn't go off Change all the keys, escape them Dj pituka
SAMSUNG UN39EH5003G
Reduce LED current Put a 0.22r resistor in series with 0.3r r9113 on the main board Eletrônica Cecé. Brumadinho MG
SAMSUNG LT22A550, LT24A550, LT27A50
TV doesn't turn on, when you press the button to turn it on, the standby LED flashes red several times and then stays solid again and doesn't turn on. Main board defect To avoid changing the main board, just remove the transistor q202, ic1601 and ic1204 and run to the hug Dimerson Eletrónica
SAMSUNG UN40EH5000
Does not turn on, does not light up st-by LED Ic 202 short Replace Maurilio
SAMSUNG UN32J4300AG
XZD 		White screen with osd working normally Short in the vcm line on the v-con board overheating the range ci Capacitor c40 at the tip of the board next to the power button on the v-con board removes and normalizes Deivisonbr