Samsung Repair Tips
Search: samsung
Results: 3844
Results: 3844
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
T22A300
|
The LED blinks, it doesn't turn on. | Replace zdq853 e zdm851. | electronicssupplyparts - Gramado/RS | |
| SAMSUNG |
CL 29Z58MQ
KS7D |
TV doesn't turn on nor does the front LED light up | R. 802 of 120k measuring more than 70 mega | Replace the same | Edezio Floriano |
| SAMSUNG |
PL51F4500 4000 4900
|
Power supply test outside the main board | Short pins 2 4 6 together with pins 1 3 5, that is, these six pins of the connector that goes to the main board are shorted together and connected to stby pin 14, remember that the power supply must be disconnected from the main board and the ysus and zsus, then short the pson pin to the ground pin or better pin 13 gnd to pin 15 stby, the power supply must provide all voltages of 15v, 5v, va, vs... ok ...you will have to supply these voltages, if it is ok...just analyzing the rest, main board, ysus, zus, screen.... | MIGUELTV | |
| SAMSUNG |
T22C310 LB
|
The LED does not turn on or light up | Ic 1601 tp 54328 torrado | Can be replaced by ic tp 54327 | nadobom |
| SAMSUNG |
UN32EH5300
|
Shaky and doubled image. | Isolate pins 43 and 44 of the second flat that connects the t-con to the display. In my case it was 100% | GILSON | |
| SAMSUNG |
943SNPLUS
|
Blue LED blinks and won't turn on | See 10 micro smd capacitors on the display board (cb25) | To replace | Marcelo Pires |
| SAMSUNG |
943SNPLUS
|
Blue LED blinks and won't turn on | See 10 micro smd capacitors on the display board (cb25) | To replace | Marcelo Pires |
| SAMSUNG |
740N
|
White screen | See smd fuse (written k) on the display board | Marcelo Pires | |
| SAMSUNG |
740N
|
White screen | See smd fuse (written k) on the display board | Marcelo Pires | |
| SAMSUNG |
LN32B530
|
Does not turn on, stand by LED blinks | C2702 is shorted c8502 (next to ci ic 8005) | Replace. | Maurilio |
| SAMSUNG |
CL29Z50Q
|
I'm sound | Change the rv960 4k7 resistor, in the middle of the two transistors next to the sound output disconnector. | DJ PITUKA | |
| SAMSUNG |
LN32B530P2M
|
Dark screen, backlight off. | Rp812 open. next to ci fan7530. | electronicssupplyparts - Gramado/RS | |
| SAMSUNG |
LN32B530
|
Standy by flashing, tsound is no sound or image, sometimes it turns on for 5 seconds and turns off flashing stand by. | Changing the 100x450 capacitor of the power supply without measuring | Run to the hug | digital system |
| SAMSUNG |
UN48H4203AG
|
Does not turn on, not even on standby inoperative! | Power supply, for testing, just remove the cable from the cnm803, the TV has to turn on the backlight without the main board, otherwise it's not the same power supply. | Replace the same! or make the repair, in my case it was short and open protection component. fuse fp801s, and short qp801s and cp810s blown. | JOHN GAMES |
| SAMSUNG |
CN 5083
|
One of the colors predominating | Tv internal rbg configuration | Turn off the TV and follow the sequence: mute>1>8>2>power, the settings will appear, enter white balance and standardize colors at 128 | Nicolas Rogerio |
| SAMSUNG |
UN40D5500RG
|
Burning the leds, backlight | Excess voltage, current | Reduce the LED current. replace the 2r4 resistor (r9120) with 3r9 -3w | Marco Gasparatto |
| SAMSUNG |
MX-F630
ZD |
Low sound, or no sound. | Falta power supply +zzz | Diodo dm811 in4148 smd. | Carlossbs |
| SAMSUNG |
MX-J640
Y28U1XOG605381K |
Power supply | Low volume | Nix | |
| SAMSUNG |
UN48JU6000
|
STBY LED flashes 5 times, no image, see SMD capacitors with leaks on the display plates, | See capacitors on the display plates, smd, short causes the 3 a smd fuse to burn, on the t-con, next regulator d5zv | Marcelo Pires | |
| SAMSUNG |
UN40H5103AGXZD
WS02 |
Stand by LED does not turn on | Defect in the 3.3v line | Replace smd capacitor zc2016 see adjacent has 2 more capacitors in parallel to this one | Paulo Pinho |