Samsung Repair Tips
Search: samsung
Results: 3802
Results: 3802
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
TV SAMSUNG |
CL21Z50MQ
|
TV with high power supply had 230 volts instead of 120 volts | C 846 totally dry de2200uf/16v | eletronica manaus | |
SAMSUNG |
CL-29Z58MQ
|
Does not tune in to TV channels. | R 830 of 15 k, on the open 33 volt line. | Carlos Maia | |
SAMSUNG |
CN 5029V
|
Stand by LED lights up but doesn't turn on | Resistor 826 ( 0, 47r 1/2 w) | Replace the same | BARRETO CRUZ |
SAMSUNG |
CL21Z43MQ
|
Does not work on 220 volts | Cq0765rt | Replace | Mauro Mascarenha |
SAMSUNG |
CL21Z43MQ
|
Does not work on 220 volts | Cq0765rt | Replace | |
SAMSUNG |
CL21Z43MQ
|
Does not work on 220 volts | Cq0765rt | ||
SAMSUNG |
LN32B530
N70A |
Tsound was only an image on one part of the screen (left side) and on the other half only in the corner +/- about 10 cm also with an image. | After checking the flats on the t-con board and not finding any anomalies, I started checking said board wsound I found ba301 open, I put a jumper with a cable on each terminal, the TV returned to normal. | Open ba301, perform the above description. | edumiguez filho |
SAMSUNG |
CL 29M21
29M21MQ |
LED off relay arms and disarms | C 815 change without measuring | eletronica martins ubatuba | |
SAMSUNG |
29M21MQ
|
LED off high power supply 200 volt | Curto diode d809a | waldenir eufrasio | |
SAMSUNG |
CB20P30BZ
SCT11D |
Shows white lines at the top of the screen after replacing the ic301 (tda8356) which was burned. | Replace eeprom | Majoaota | |
SAMSUNG |
CL-21Z58MQ
|
Vertical closing at the top and doubling the image, tsound is no power supply on pin 6 of the ic301 | Diode d303 open, just change it and it's solved | valmirgold | |
SAMSUNG |
CL14C600
|
Turns on with white screen with spots and turns off | C303 100uf 50v broken | Replace without testing because in the test it measures good | antonio nobrega |
SAMSUNG |
CB14F1- CHASSIS S15A
|
Not the image | If you carefully increase the g2 you will see the image very dark and with return lines | Replace r420 from 120k situated abl circuit | Ruyzovich |
SAMSUNG |
CB14F1
S15A |
The STBY light does not come on, tsound is only 300V present at the power supply | Dz808 | Replace zener diode | Ruyzovich |
SAMSUNG |
CB14F1
S15A |
The STBY light turns on, but it doesn't start and the power supply makes a soft ticking noise | Pc801 | Replace opto coupler | Ruyzovich |
SAMSUNG |
CB14F1
S15A |
The STBY light comes on, but it doesn't turn on | The 220uf - 400v capacitor on the power supply burst and lost liquid | Wash/clean the liquid spilled on the chassis thoroughly and replace the capacitor | Ruyzovich |
SAMSUNG |
CB 5035Z
SCT11B |
Image out of sync | Ic 201 | Replace m52309sp | Ruyzovich |
SAMSUNG |
LN32B350F1
|
Standby LED blinks, but no image appears | Electrolytic capacitor (defective voltage 160v, normal 400v) | Cp 815 100/450 | ELETRO CENTER |
SAMSUNG |
21Z58MQ
|
This TV arrived at the workshop and it didn't work after I put it to work, it showed a very dark image and with 50 v on the screen in the kinescope board socket. | Rewrites the memory. | Reset the memory or replace | OP Eletrônica(Ozenildo) |
SAMSUNG |
CL-21Z43MQ
|
Slightly blurred blue screen with spiral retrace lines | 5v6 zener diode, zd201 position with leakage | Matoes A. Tecnica |