Samsung Repair Tips
Search: samsung
Results: 3802
Results: 3802
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
CX5944X
|
Does not work, input fuse destroyed | Ptc, on circuit p801, 07ms03fc. replacing the fuse and ptc with an fc7ac27m270. | Manoel L. Silva | |
| SAMSUNG |
CX3312Z
P58SC |
Trapezoidal image, narrower at the top than at the bottom, with 3 vertical folds. | Horizontal deflector coil with corrosion/verdigris. | Manoel L. Silva | |
| SAMSUNG |
CW30A90SD,
SCT53A |
The horizontal output transistor burned out | Flyback | Manoel L. Silva | |
| SAMSUNG |
CT26F75W
|
Doesn't start | C802 dry and diode d803 short. | Manoel L. Silva | |
| SAMSUNG |
CN7266
|
It doesn't go out of standby, the front LED doesn't light up, the voltages are all normal. | Flat cable from the front panel of the TV and the remote control is also defective. | Manoel L. Silva | |
| SAMSUNG |
CN533CX, 551A
|
Does not tune, although the osd seems to do so, the tuning voltage does not change. | C901(150pf) ceramic, near. pin 1 of ic saa5297ps/238 | Manoel L. Silva | |
| SAMSUNG |
CN5083V
|
With sound, but dark screen and no image, when opening the screen the screen was blue and with retraction lines | Missing sand-castle pulse on pin 5 of ic501 tda 4662 caused by leaky d410 | Manoel L. Silva | |
| SAMSUNG |
CN5083V
|
High power supply | C825 470µf/16v no primary power supply | Manoel L. Silva | |
| SAMSUNG |
CN5083V
|
Does not turn on, nor does the LED light up | Choper transformer with bad turns | Manoel L. Silva | |
| SAMSUNG |
CN5062Z
|
Mon funhoso e intermite. | R608 10k open on the sound fi circuit. | Manoel L. Silva | |
| SAMSUNG |
CN5062
|
Suddenly it divided the image in half (horizon drive type definition.) | Feedback diodes, d404 and d405 | Manoel L. Silva | |
| SAMSUNG |
CN5048V
|
Background image, with overlapping portraits. | Change the ic201 | Manoel L. Silva | |
| SAMSUNG |
CN5048V
|
Lines of retractions and colored lines at the top of the screen and protecting | 100uf/160v dry electrolytic capacitor and open r304. | Manoel L. Silva | |
| SAMSUNG |
CN5038VB
|
Does not work; stand by LED lights up; relay knocking (on/off). | T444= fsv20a001(flyback). d404=tvr10g963 (fast recovery diode). equiv: byv27-200 | Manoel L. Silva | |
| SAMSUNG |
CN5038V
|
Beam deviation (blurred spots) | Tda 8356 and the cut pipe. | Manoel L. Silva | |
| SAMSUNG |
CN5038N
|
Zener d815 short | Replace zener d815 | Manoel L. Silva | |
| SAMSUNG |
CN5029Z
|
Dark screen, with sound and no image | Screen capacitor c534 on the tube plate. | Manoel L. Silva | |
| SAMSUNG |
CN3383V
|
Power supply does not oscillate. | Power supply traffic | Manoel L. Silva | |
| SAMSUNG |
CN3383
|
It takes two minutes to call | Altered horizontal driver | Manoel L. Silva | |
| SAMSUNG |
CN3383
|
Didn't care. the voltage of the power supply and the micro and processor were all ok. | Horizontal driver transformer with its altered homic resistance | Manoel L. Silva |