☰

Samsung Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: samsung
Results: 3802
Make Model Symptom Problem Solution By
SAMSUNG CL20K40MQ
Reduced frame vertically and horizontally / without weft Microprocessor Replace the same eletronicaapolo
SAMSUNG CN - 5083V
Reddish image. R-917 and 923 amended. (crt board). FERNANDO S
SAMSUNG 32
Does not turn on the screen only has sound R 908 Remover o resistor Marcos
SAMSUNG DVD-R150
No characters on TV screen, tray locked No characters or images appeared on the TV screen either through the video or RF outputs and the tray was locked, with the word open appearing on the display. three 1000μfx10v capacitors (ppcf1/ppcf2 and ppcd1) were replaced. on the capacimeter they showed an average of 1,150μf but they were the cause of the problem. replaced with three 1200μfx16v removed from a motherboard, it worked perfectly again. littlecarlos
SAMSUNG CL21M6MQ
It wouldn't turn on: 1 n 805 diode and 1 n 812 dzener were replaced Now turns on the power supply and the LEDs but the horizontal one stays on and off with the smaller frame and retraction line JANUARIO VITOR
SAMSUNG CL-29M21MQ
It doesn't work, only the stand by LED is on, press the power key, nothing happens, 6 VDC power supply measures 4.5 V After changing all the voltage regulators, the microwave was also replaced (which was overheating) and the TV started working again. EDGAR THIZ
SAMSUNG CN-3329V
Noisy power supply on stand by C852 changed. After replacing it it was normal Fuão
SAMSUNG CL21Z43
With audio without image Change c508 on the kinescope PCI ELET. CENTRAL ITAPOLIS SP
SAMSUNG 29K40MQ
Burning of r423, to the point of damaging the PCI C404 open generating excess horizontal synchronism signal under r423 causing overheating I redid the PCI and replaced r423, c404 and components damaged by heat ivan
SAMSUNG CL21K40MQ
Dark screen, no characters After several tests, it was found that the red cannon was exhausted, it was just a matter of reactivating it. pedro eugenio
SAMSUNG CL21K40
Horizontal line about 5 cm to the side To solve this defect, change the r414, a big hug To solve this defect, replace the r414 and run to the hug DAVI DE PEIXE-BOI
SAMSUNG CL21Z43MQ
I'm sound Coil l201 open cutting 8v supply on pin 87 Replace coil Fabio Dullius
SAMSUNG 21Z43MQ
Dead power supply Diodo zener dz803 33v com fuga Replacement Alvaro (prolar)
SAMSUNG CL21A551ML
Right side list Heating horizontal output D 403, open e matos. eletronica
SAMSUNG 247 OHN
TV monitor won't turn off I don't know Costa
SAMSUNG 247 OHN
TV monitor won't turn off I don't know Costa
SAMSUNG 5039VB
KTC12A 		Tuning C246 2.2x50v near the micro joaomvjr
SAMSUNG 21K40MQ
After changing fly back, vertical closed at the bottom, power supply -16v with -5v With the fly just, wind turns on the fly ferrite and put it in series with the power supply -16 (04 turns will solve the power supply for me with -9 and opened the board) WARLEY CESAR
SAMSUNG CL-21Z50MQ
Standard power supply but when you press the switch the power supply goes up to 180v Q 805 on the run mecinhor7
SAMSUNG CL-21M6MQ
Without image, but with sound It didn't turn on, the flyback, power supply, transistor output hori were replaced. The TV started working again but the image went dark after a few seconds and only the sound remained. The ic501= tda 6108 was replaced. It was ok. LOU