Search: samsung
Results: 3802
Make Model Symptom Problem Solution By
SAMSUNG LN40B530
Does not turn on reverse Resolder resistors rb803,rb804,rb805,rb806 pardalzito
SAMSUNG LN26B450C4M
Turns it on and goes into protection, put a 5.6 vts zener diode on the on-inv and a 4.7k resistor on the + 13 vts No image when turned on - just the sound. Zener do terra p/ on-invert- restor p/ 13vts TV TECNICA BRACEL
SAMSUNG MAX-A66
Protection acting Qm1 shorted at power supply Replace ELETRONICA SOUZA-MACEIO/AL
SAMSUNG CL-21M21MQ
Strong whistle on the flyback as if tsound was an internal leak, horizontal output heating up, no image, normal sound, when opening the screen you notice a reduced picture with shutter-like lines. Deflector coil with shorted turns. I used an LG one and it worked beautifully. Altevirlima_Valparaiso Eletrônica_PA
SAMSUNG CL29C650GQ
When turning on the television it works normally, after a while the screen darkens and the image disappears leaving only the sound and the OSD (characters) when entering service mode you notice that the OSD is deformed (trapezoid) Change eeprom (memory) do programming. WAGGUINHO
SAMSUNG CN5039VB
Retrace lines with a predominance of a single color R511 or r512 or r513 /replace for 100k This email address is being protected from spambots. You need JavaScript enabled to view it.
SAMSUNG CL21Z43
I'm sound Zd901 with leakage voltage a+5v was below.
SAMSUNG LN32B350F1
Doesn't start Dm857 - power supply board tyko
SAMSUNG CL-21Z50MQ
Turn on and off Capacitor da power supply 220/400v It can be replaced by 330/400v Marcondes, jaicós-PI, OHM Eletronica
SAMSUNG CN-3383VB
No horizontal synchronization Replace ci tda8361... pfa
SAMSUNG LCD LE32R74BD
Does not work, noise originating from the PSU, the LED blinks. Check for short in the DM854 diode (MBRF1545CT) on the PSU. Marcio Santos
SAMSUNG LCD LE32R73BD
No image, no osd, blacklight ok. Resolder lvds connector on the screen driver board and on the main board Marcio Santos
SAMSUNG LCD LE27T51B
Dark frame with colored bars. Unstable voltage problem. Check and replace UP4 (L1117DG) on T-CON board. Marcio Santos
SAMSUNG CL21C650ML
Vertical closed risk crooked Deflector coil wire is broken under the glue Remove the glue and you will see broken thread white glue is not red ELETRONICA MAURI JUNIOR
SAMSUNG CL21Z43MQ
KS9C
Doesn't work Cq0765tr Pedro Eugênio
SAMSUNG CL21Z58MQ
Green screen with image, warping at the top and with the top a little closed Rewrite data from memory Pedro Eugênio
SAMSUNG LN40B550K1
Entering stand by and LED blinking Power supply board Font replace itan(cabeça
SAMSUNG LN32B350
With sound but no image Thanks to my friend roberto reparas for the tip, to put an r=4.7 k between pins 16 of the ic without 2006 when inverting the socket, thanks dear, thanks Resolved gerra
SAMSUNG CL21Z43
Very dark image C 508 Replace c de 472x3kv Felex
SAMSUNG CL21C650
With sound and image in half with scratches on the top and turning off D303 changed swap without test Direct Som Eletronica