Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	TV-2159 U-18	Fast blinking led	885 open diode		jackssom
TOSHIBA	TV2158 NFS U 18	Rgb, image turns bluish and menu wobbles, sound is bad	Change q 606 ik line		ELETRONICA ROBSON(DEBIQUE)
TOSHIBA	TV-2998-FMS	The device turns on, after a few seconds it goes into stand by mode.	Oxidized solders on the pins of the ic 8809cpbng 3po2, q-501. also check the solders of the ic- q-301. it's ok.		CLÁUDIO RIBEIRO, TECNOSAT ELETRÔNICA, JATAÍ-GO.
TOSHIBA	2091 U14	When switching from one channel to another it appears to be in tune.	Check 1uf/100v cap a55 may be broken or dry		Daniel...
TOSHIBA	U14 U14	The TV only has standby on but it doesn't oscillate and tsound's no high voltage. I checked that the power supply was low, with approximately 80 volts on the +b of the flayback, I even changed all the transistors on the power supply and up to 432 smd, but nothing increased the voltage on the power supply. +b. I decided to change her computer to the 8813cpng3rp2, then it shot and fell. but the problem was still not completely resolved, it would turn on but the menu would appear on the screen and then turn off. I replaced the d840 and the q840 from the power supply, both were bad, so yes, the TV was fileeeeeeeeeee	Micro e q840e dz840 (regulator diode)		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	2098 U14	The TV only has standby on but it doesn't oscillate and tsound's no high voltage. I checked that the power supply was low, with approximately 80 volts on the +b of the flayback, I even changed all the transistors on the power supply and up to 432 smd, but nothing increased the voltage on the power supply. +b. I decided to change her computer to the 8813cpng3rp2, then it shot and fell. but the problem was still not completely resolved, it would turn on but the menu would appear on the screen and then turn off. I replaced the d840 and the q840 from the power supply, both were bad, so yes, the TV was fileeeeeeeeeee	Micro e q840e dz840 (regulator diode)		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV2090-H AV U13 U 13	Doesn't start	When turned on, it opened f470	Diode d302 was replaced with the original one and q301 with la78040, once this was done the device started working normally again.	jair.com2008
TOSHIBA	2987 EMS	Without vertical and horizontal synchronization	C214 sem capacitance		claudioaudioevideo
TOSHIBA	TV2998EMS LEM2	Turns on and off on the remote control blue or dark screen without characters without audio	Tb1275an	Replacement	GENIVALDO
TOSHIBA	2098 U14	When the TV was turned on, it worked for a few seconds then the menu appeared on the screen and then turned off, I even thought it was the memory but it wasn't	It was a completely open diode, the d840 and also the transistor q840 was changed		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV1488 U14	Vertical with several flickering lines at the top of the screen	C301 ranging		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV1488 U14	Reduced vertical top and bottom with a clear bar in the middle of the screen	Q421 auterated 5v regulator		Antonio do Radio Flores PE
TOSHIBA	TV 2095 U15	No characters no image almost inoperative	After checking everything, r 62 was found open	This resistor is 10k in smd close to the memory solved	valdemiro This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	TV2922-IFS FS7	I'm sound	Replace do transistor smd bc858 q625		GEMASI
TOSHIBA	TV 2996	TV doesn't turn on	Good morning everyone, this TV sometimes turned on and sometimes didn't, the power supply went out when turned on, in stand-by it made a certain noise in the speaker, and the on/off relay kept "knocking". I re-soldered the board and checked the cp. 819 and cp. 842 with probably loss of capacity, replaced them and it was just joy. I hope this tip is useful to someone. have a good weekend everyone.		sebastião
SEMP TOSHIBA	1470E	Does not tune (no reception)	R102 (18k)		André Luiz
TOSHIBA	2089 U14	When the TV was turned on, tsound was no sound, but tsound was an audio line at the output. But a few minutes later, when it was warmed up, you just had to turn it off and turn it on again and the sound would go off.	Electrolytic capacitor c887 (100mfx35v) change it without measuring it on the capacimeter, as a precaution resolder the audio area completely		This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA	U14 U14	It doesn't turn off on the control, when you press the power button (CR) the TV only erases the image.	R 437 10k open
TOSHIBA	2999	When you take q432 it works	Q432 burned	Q432 replacement	Hofman
TOSHIBA	2999	Without flayback oscillates and with no	Transistor q432		Hofman