Toshiba Repair Tips
Search: toshiba
Results: 5617
Results: 5617
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
TOSHIBA |
1400TBT
|
Field jitter | Repace d315 ( 7.5v ) zen | ||
TOSHIBA |
1400TB
|
Snowy pic | Tuner lecher bars corrosion | ||
TOSHIBA |
1400TB
|
Field scan excessive & no adj | 2 x 2µ2 caps in field fback cct (usually red or brown) & d315 7.5v leaky zener | ||
TOSHIBA |
1400TB
|
Field non lin | Check c317 2µ2 50v & c303 2µ2 50v (behind 4.43 xtal) | ||
TOSHIBA |
1400TB
|
Chopper tfmr buzzing aft crt change | Connect 330r ½w res across r814 | ||
TOSHIBA |
1400RDT
|
Dead | Str50020 u/s; damper diode s/c & several resistors but loptx was faulty | ||
TOSHIBA |
1400RBT/RBW
|
Field collapse | C303 2µ2 ramp gen cap leaky & c317 2µ2 in lin fb cct leaky causing vert centre fault | ||
TOSHIBA |
1400RB
|
Tuning drift | Replace da34 ptn 23115599 | ||
TOSHIBA |
1400RB
|
Field lin dist | C317 (behind field chip) & c303 (behind if can) both 2µ2 & red | ||
TOSHIBA |
1400RB
|
Field cramp / stretched at top | C303 2µ2 pin 13 ic501 jungle chip | ||
TOSHIBA |
1400RB
|
Auto tune not locking on | Replace qa06 no aft on pin 8 ica01 or replace qa16 no sync on pin 9 ica01 ptno 233114689 | ||
TOSHIBA |
1400RB
|
500ma fuse f803 in ht line blew int | 3 rubber wedges on crt conductive - scan coils arcing to them | ||
TOSHIBA |
ALL NEW SETS
|
Unable to get install menu | Software glitch. put into stby and then switch on using r/c (not on/off switch). set will now perform normally | ||
TOSHIBA |
2,14E+06
|
Set dead stby led goes out when r/c pushed but set | Sd15 (0.039F) | ||
TOSHIBA |
2,12E+06
|
Low , dist sound | Let's go | ||
TOSHIBA |
2939
|
Int blue screen | Change tuner | ||
TOSHIBA |
2939
|
Faint blue screen with no manual or remote functions | Replace zp81 and ic670 | ||
TOSHIBA |
2812
|
Servive mode access | Press "f" and the av i/p key ( under the no 7) together... then key 1 0 4 8 .. then "f" and green fastext key to move up the menu, "f" and yellow to move down.. adjust with vol up/down key | ||
TOSHIBA |
2812
|
Lack of width/tearing | C424 4.7uf 100v on the upright dpc board and c301 | ||
TOSHIBA |
2812
|
Int tripping | Ground pin 52 of ic501 |