Toshiba Repair Tips
Search: toshiba
Results: 5592
Results: 5592
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP TOSHIBA |
TV2091KA
|
Horizontal output shorted | Substituir capacitor c419(45uf/50v) | Recommendation: check the quality of the horizontal output transistor, use darlington bu808dfx | Luir |
| TOSHIBA |
TV2157BFS
FS2A |
Dark image only appearing when changing channels | Screen voltage with less than 300 volts, the correct one would be more than 400 volts c902 which is on the kinescope board. | Remove the capacitor and turn on the TV if the image appears, replace the c902 1nf/2kv | Eletrosonic (Helio) |
| TOSHIBA |
TC-2157BFS
LEM7 FS2A FS5 |
Dark image only appearing when changing channels | Screen voltage with less than 300 volts, the correct one would be more than 400 volts c902 which is on the kinescope board. | Remove the capacitor and turn on the TV if the image appears, replace the c902 1nf/2kv | Eletrosonic (Helio) |
| SEMP TOSHIBA |
LC3245F, LC4045F, LC4245F
|
Locking keyboard and remote control | Check the value of the smd resistor in position r602, itsΩic resistance must not be less than 4k7, if it is below this value the track that goes to r580 must be open. | ||
| SEMP TOSHIBA |
LC4245W
|
Enable Audio out output when using hdmi connection | 1) remove the smd resistors from positions r346 and r347. 2) replace the 33k smd resistors in positions r214 and r217 with 330k smd resistors 3) add jumpers from the positive terminal of capacitors c211 and c212 to the Audio out connector terminal, as detailed below. | technical bulletin | |
| SEMP TOSHIBA |
LC3245W LC4245W
|
Low sound introduces noise in the audio | Isolate the PCI from the chassis, removing the SMD jumpers that connect the PCI ground to the chassis ground. in the position of the m806 screw, next to the tuner tsound is no jumper, so isolate the fixing screw with the chassis by placing a paper or plastic washer on the top and another on the bottom. | ||
| SEMP TOSHIBA |
LC1510Z
|
Washed canvas | U27/d40 c370 e c69 | amram | |
| TOSHIBA |
TV2159
U18 |
Sidebar image shifted to the right, no reaction to cr, does not obey volume keys, no characters. | D 418 with leak, connected to pin 10 of the fly | Substituir diodo zener 9,1 v | eletronicard |
| SEMP TOSHIBA |
TV2122
|
Vertical closed | Check diode 885 | Sequeira | |
| SEMP TOSHIBA |
TS167 TS207
|
Jagged image with flyback noise | Check c408 (10/16v) | Sequeira | |
| SEMP TOSHIBA |
TS167 TS207
|
Power supply low, screen increases, voltage drops | Check r613 | Sequeira | |
| SEMP TOSHIBA |
TV2070
|
Image closed on the sides | Check q803 | Sequeira | |
| SEMP TOSHIBA |
TV1480 TV2080
|
No characters | Check ra98(47k) | Sequeira | |
| SEMP TOSHIBA |
TV1480 TV2080
|
Sound only at maximum volume | Check ra17 (3k3) | Sequeira | |
| SEMP TOSHIBA |
TV2092
U16 |
Horizontal transistor burns out or heats up too much | Verificar c419 (47/50v) | Sequeira | |
| SEMP TOSHIBA |
TVC160
|
Image with scratches at the top | Replace c310 (4,7/160v) | Sequeira | |
| SEMP TOSHIBA |
TVC160
|
Vertical partially closed | Verficar q803 (2sb546) | Sequeira | |
| SEMP TOSHIBA |
TVC160
|
Power supply takes time to start | Verificar c811 (10/100v) | Sequeira | |
| SEMP TOSHIBA |
TV2490
U14 |
Power supply with oscillations | Verficar R876 (220R) | Sequeira | |
| SEMP TOSHIBA |
TV2090
U13 |
Scratches at the top of the screen | Change c308 | Sequeira |