Search: toshiba
Results: 5617
Make Model Symptom Problem Solution By
TOSHIBA MS7704MP3
It turned on, the panel lit up but nothing came out. When I pressed the volume button it made a few clicks. Change c406 of 47k and c420 of 220x16v on the power supply line on pin 19 of ci bd3883. they were shorted. replaced ok. nachbar
TOSHIBA MS6530CD
The display does not light up, only the function buttons C903 e 904 (100x50v) eletronica vieceli
TOSHIBA TV2987
LEM-6
Turns off in seconds image appears and turns off if you increase the screen and retrace line Change vertical ci 9302 and electrolytic of 100 close to vertical ci Edmar Silva
TOSHIBA TV2998GMS
LEM4
When turned on, it turns off immediately or even stays on and when you twist the PCI it turns off. In addition to giving an overview of the PCI solders, check with special attention the R427 SMD and 426, these are connected to pin 9 of the fly BRUSKE
TOSHIBA U18
Sometimes it turns on, it works normally. it turns off then it turns on, it doesn't turn on + the LED keeps flashing C865 > leaking Just replace D & E ELETRONICA
SEMP TOSHIBA TV 2999
LEM 7
Running away brightness, does not brighten image, dark image. 1k c902 replacement on tube plate. I just replaced the c902 Tecnico Jose Adriano
TOSHIBA TV2981KAVS
LEM7
Does not tune AV input channel does not work Q02 Replace qa02-br24l04-e2 eeprom E.RIBEIRO
TOSHIBA TV2958HFS
916673
The standby light does not come on When tsound is a power outage, when you plug the plug into the socket, the standby does not turn on Raimundo
TOSHIBA TV2981KAVS
LEM7
Can't tune the channel C180 Replace E.RIBEIRO
TOSHIBA TV2981KAVS
LEM7
Swap q862 photo coupler ps2581f Q862 Swap q862 photo coupler ps2581f E.RIBEIRO
TV TOSHIBA TV 2958FS5
TV works with green screen characters in green Diode d906 shorted on the crt board. Replace diode and TV returns to normal afonso Eletronica taquari
TOSHIBA TV2058S
U6A
Dark image. Even increasing the brightness and contrast, the image becomes dark. R227 changed or opened Replace r227 (24 k) toinho eletron
TOSHIBA TV2959FS8
LEM10FS8
Dead S801- open Replace s801 chave power E.RIBEIRO
TOSHIBA TV2090HVA
TV was only on standby but it didn't oscillate and tsound was no +b on flayback When checking the chassis, the 500ma fuse was blown, bu, and the d302 diode that takes power from the flayback to the vehicle was also shorted, so when checking the tda 9302h it was also shorted. All the components mentioned were replaced and the TV was fine. This email address is being protected from spambots. You need JavaScript enabled to view it.
TOSHIBA TV2056M
U6
114v low power supply Broken track between d807 and t803 Jampear E.RIBEIRO
TOSHIBA TV2998EMS
LEM2
Turn on right after turn off Transistor q830 with cold soldering I solved it, it was ok paulo
TOSHIBA TV2922 FS7
Only in stand-by with the +b varying and a noise like a pacifier leaking, I tried to change the photo coupler but it was not possible. Fly-back damaged. carlinhos100
TOSHIBA TV-2177-ASL
SL-11
Part and stop or part and cut. +b or normal secondary power supply. Open (1k) resistor ra16 (protection line pin 71 of the handyman). Replace ra16 from 1k and good luck. George Pontes
TOSHIBA 2987CSU
U9
TV turns off by itself, works for about 10 minutes then turns off by itself, to turn it on again you have to unplug it, and as it heats up the time it stays on decreases. Altered capacitor, c 418 of 33mf 160 volts Replace the capacitor, you can put 47mf for 250 volts Ricardo Alves Eletrônica do Ricardo - Caeté MG
TOSHIBA U15
LED on and doesn't turn on +b with 120v After 2 days of work I discovered the Q 404 base track was broken BETO ELETRONICA ACRELANDIA AC