Search:
Results: 88017
Make Model Symptom Problem Solution By
LG 49UJ6300
The LEDs don't light up Shorted LED bar All I had to do was remove the ends of the shorted bars and replace some LEDs and it lit up. jrmc.63
TV SAMSUNG LN32B530P2M
.
It doesn't turn on, the LED keeps flashing. Lack of capacitance no cm852 1000 microfarads giving 680. Replace cm852 in the power supply wellingtoneletronicasilva
PHILCO PH29T21D
Turning off by itself Driving keyboard keys Replace the keys and clean the PCI GIOVANO ELETRONICA
LG 42LH30FR
EAX56856906
I'm sound Smd capacitor depleted position c809 Changing the c809 10μF 16v, close to the processor SOS Televisores
LG 42LD460
Does not turn on. does not even light up on standby. good power supply Remove the sw1001 touch key from the main board..and clean the board well..wsound the key is..leave it without the key. because she is driving. fernando
PHILIPS 32PHG5201
Doesn't start No voltages on the cn9101 jack. diode d9102 (sr515) shorted, q9101 open (k8a65d) and resistor r9101 (vm /lilaz/prata) open. Replace them all. check voltages. BICHARA SARQUIS
LG 28MT
Increase the volume alone Follow pin 2 of the connector that goes to the function keyboard, and remove the first resistor that goes to ground Rodrigo cofferi
AOC D42H931
Turns on normally, but most of the time it comes without sound When you turn it on and it has sound, if you turn it off and turn it on again, it has no sound. U602 (g1084 33 small to252), lower left side of the top of the main board..down tsound. MIGUELTV
PANASONIC TC-P50G11B
TV turns on normally, after a few seconds it turns off with the red LED flashing 11 times One bloated capacitor (position c253 of 1400uf by 220v) and two with half-life of use (position c353 and c355 of 820uf by 80v) all on the power supply board Replace the c253 with a 1500μF capacitor at 250v and the c353/c355 with a 820μF capacitor at 100v and the TV started working normally again FridayTechLab.
SEMP LC4055
TV without audio, with normal image and normal tuning No sound, r264 (4.7k smd resistor) open or removed (stays on eternal mute) (never eliminate r264 in this model) Replace a 4.7k resistor in r264 or replace it. audio returned normally (note: the lid plugs must be connected to this TV model to output audio) Mauricio Nunes - FOCONET
SEMP LC4055
FDA E OUTROS
TV works normally after changing the power supply (card). but tsound is no audio, even when connecting the headphone output cover connectors. (note: without the plugs on the rear cover plate, tsound is no audio) Without sound and with image remove the smd v204 transistor and jumper the collector and emitter and "only flowers" this is the tip from focanet electronics - mauricio de Salto-SP Remove/eliminate v204 (smd transistor) and jumper (join) emitter and connector with a thin wire. Mauricio Foconet Salto
TCL 32S6500S
32S6500S
Does not turn on, no standby. Changed resistor ru12. Resistor r12 4r7 replaced, it has high impedance, it was identified because it was cracked. Replace the 4r7 resistor with any 4.7Ω resistor and the power supply returned to normal voltage.
SEMP U19
Does not turn on, no stand by LED and has ok primary power supply No secondary power supply R860 open in primary power supply (220k) Deo Eletronica
LG 32LK450 42LK450
Does not tune channels Falta 5v no +b do seletronic R466 r467 prox. ic406 DsInfo&Eletro
LG 49LJ5550
Merged image crashing with 1 line going up In my case, I just changed the tcom and went for the hug Eletrônica moura trindade
SONY KDL 42W655A
TV varied colors in the image! symptom display Clean the tcon cable system (or change it) be careful when assembling these TVs they may end up in protection mode! and don't forget the lands! (this TV is f@##₩)
SONY KDL32BX355
Turns on and the lamps do not light up, code of 6 flashes on the red LED Defect in the inverter board, however tsound are 2 different inverter board models for this same model Replace the IC drive on the inverter board and solved it marco.32
PHILIPS 55PUG6700
Dead TV won't turn on. power supply with all voltages. board processor heating up normally, optical audio output with light. voltages in the main apparently ok. Even so, it doesn't generate an image TV does not turn on - place the hob in an electric oven or oven for 10 minutes at a temperature of 280 degrees. obs. I only added this tip 120 days after the procedure and so far the TV is normal. GUSTAVO STEFANON
SAMSUNG UN40FH6203G
Turns on with sound but without video and backlight Open 5a fuse + a shorted ceramic capacitor on the t-con board Inject voltage into the fuse with a 18650 battery and identify the shorted capacitor via odometer. I replaced them and the TV started working normally again. Fernando All
PHILIPS 46PFL3008D
Turns on standby flashes backlight and returns to standby Remove memory plug in...turn off clean and resolder memory Whatsapp- (13)99613-2582 Betonelli