Repair Tips
Search:
Results: 88058
Results: 88058
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
UN46D5500
|
Turning off | Main board | ||
| SAMSUNG |
UN46C5000
|
Lists in the image | Cleaning the lvds cable and connector | ||
| SAMSUNG |
UN40F5500AG
|
The LED kept flashing but it doesn't turn on. She stopped on a day with lots of lightning. | Icm851 ( 43a ) shorted. | ||
| SAMSUNG |
UN40F5500A
|
The LED flashes 5 times in batches of 2 flashes and repeats | Power supply board | ||
| SAMSUNG |
UN40F5500A
|
LED flashes 5 batches of 2 times | Open led | ||
| SAMSUNG |
UN40F5500
|
Turning off after five minutes. had normal sound and image and performed all the functions | Main_unit | ||
| SAMSUNG |
UN40D5500RG
|
Restarts itself constantly | Main board. corrupt firmware. | ||
| SAMSUNG |
UN40D5500RG
|
When turned on, it turns off the screen and then turns on by itself and stays on and off | Main board | ||
| SAMSUNG |
UN40D5500
|
The Samsung Smart logo appears and turns off. | Main board. the 5500 board = the 5000 board. | ||
| SAMSUNG |
UN40D5500
|
When turning on, a glow would appear on the screen and it would go off shortly afterwards. everything ok with the power supply. | Open fuse on t_com board | ||
| SAMSUNG |
UN40D5000PGXZD
|
Clicking noises during operation! | Insulating tape was placed between the rear cabinet and the LED panel. | ||
| SAMSUNG |
UN40C5000QM
|
Does not come out of stand by | Dp803 shorted | ||
| SAMSUNG |
UN32F5200AG
|
It doesn't turn on and stays on standby blinking. the pfc is low (280v). | LED panel connector with sunken pin. I didn't give enough contact. | ||
| SAMSUNG |
UN32F4200
|
Dark screen | Fet d3n4 and open leds | ||
| SAMSUNG |
UN32EH5000G
|
Doesn't start | Hand plate | ||
| SAMSUNG |
UN32D5500RG
|
Turns off every 2 minutes and 7 seconds. When this time is up, it turns off and on immediately and repeats. | Main board, placed on the d5000. It's more affordable, it's just not smart. | ||
| SAMSUNG |
UN32D5500
|
How to release the power supply and inverter | You don't need to do anything to release the power supply and the inverter | ||
| SAMSUNG |
UN32D4000NG
|
Does not turn off | Oxidation in the solder on the power supply board, preventing the motherboard from entering stand-by level | ||
| SAMSUNG |
UN32D4000NG
|
Does not turn off | Cleaning and resolving some components on the power supply board | ||
| SAMSUNG |
UN32D4000GXZD
|
Doesn't start. LED flashes 5 times. | Qq9101. used a mmbta92 which is a 300v 100ma smd pnp |